Mevotech MB30325 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub for Nissan Rogue

The Mevotech MB30325 is a rear wheel bearing and hub assembly engineered for 2008-2013 Nissan Rogue models. Built as a Gen 3 roll-form design, it is pre-greased and uses a non-integral ABS sensor layout for a direct replacement on the rear axle.

Key Features

• Fits 2008-2013 Nissan Rogue, rear
• Mevotech Supreme Parts application-specific design for durability-focused service
• Gen 3 roll-form construction
• Pre-greased assembly for ready-to-install service
• Non-integral ABS sensor configuration
• 4 flange bolt holes and 5 bolt holes
• Inside diameter: 68 mm; outside diameter: 148 mm

Product Details

Mevotech MB30325 is a rear hub bearing assembly for the Nissan Rogue, covering 2008-2013 model years. The Supreme Parts line is engineered in-house with vehicle-specific upgrades for demanding passenger and commercial use, including SUVs, fleets, and working trucks. This assembly is built to replace the rear wheel bearing and hub unit with a pre-greased, roll-form design that supports consistent fitment and serviceability. This part cross-references Timken HA590241 and SKF BR930731 for the same application.

Common Issues This Part Can Address

• Rear wheel bearing noise or growling from the hub area
• Excessive wheel play or looseness at the rear wheel
• ABS warning concerns related to the hub sensor configuration
• Uneven rear wheel rotation caused by hub wear
• Service replacement for a worn rear hub assembly on a Nissan Rogue

Installation Notes

Confirm rear-position fitment before ordering: Fits 2008-2013 Nissan Rogue, rear. Verify the 5-bolt hub pattern, 4 flange bolt holes, 68 mm inside diameter, and 148 mm outside diameter against the original part. Because this assembly uses a non-integral ABS sensor layout, match the vehicle’s sensor arrangement during installation. The pre-greased design helps simplify setup, but proper torque procedures and clean mounting surfaces remain important for a correct repair.

Quality Assurance

Mevotech Supreme hub bearing assemblies are built with application-specific engineering for durability-focused replacement service. MB30325 is designed for high-use vehicles and daily-driven applications where consistent hub performance matters.