Mevotech MK200175 Suspension Control Arm Bushing - Rear At Knuckle (Lower)

Mevotech MK200175 Suspension Control Arm Bushing

The Mevotech MK200175 is a suspension control arm bushing made from natural rubber for rear at knuckle (lower) applications. It is built for vehicles that need a direct-fit replacement bushing with the correct dimensions and material profile for suspension service.

This part is a single blue bushing with a 2.36-inch length, 0.56-inch inside diameter, and 1.57-inch outside diameter. It is a practical replacement choice for drivers servicing Cadillac DeVille, Cadillac Seville, Cadillac Eldorado, and Buick Rendezvous rear suspension points.

Key Features

• Part number: MK200175
• Suspension control arm bushing for rear at knuckle (lower) placement
• Natural rubber construction for suspension isolation
• Blue finish
• Dimensions: 2.36 in. length, 0.56 in. inside diameter, 1.57 in. outside diameter
• Single bushing quantity

Detailed Description

Mevotech MK200175 is a suspension control arm bushing engineered for rear at knuckle (lower) service points. The natural rubber material is selected for suspension use where controlled compliance and fit accuracy matter, and the listed dimensions help confirm proper match-up during replacement. This part cross-references MOOG Chassis Products K200175 for the same application.

Compatible With 2002-2007 Buick Rendezvous, rear at knuckle (lower); 1993-2002 Cadillac Eldorado, rear at knuckle (lower); 1994-1999 Cadillac DeVille, rear at knuckle (lower); and 1993-1997 Cadillac Seville, rear at knuckle (lower). For shoppers searching for a rear lower control arm bushing for Cadillac DeVille or a suspension bushing for Buick Rendezvous, MK200175 is the relevant part number to verify.

Common Repair Uses

• Replacing worn rear suspension bushings
• Addressing looseness at the knuckle-to-control-arm connection
• Correcting clunks or suspension noise from deteriorated rubber
• Restoring suspension alignment stability after bushing wear
• Servicing rear lower control arm mounting points on Cadillac and Buick applications

Installation Notes and Tips

Confirm the rear at knuckle (lower) position before ordering, since suspension bushings are position-specific. Compare the old bushing’s dimensions, inside diameter, and outside diameter to MK200175 before installation. Proper press-in service and suspension torque procedures should be followed during replacement to help ensure correct fitment on the vehicle.

Quality Assurance

Mevotech supplies suspension components for replacement service, and MK200175 is listed with exact fitment data and dimensional specifications to support accurate part selection. Verify the vehicle year, make, model, and rear lower knuckle position against the fitment list before installation.