Mevotech MK3110 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Mevotech MK3110 Front Stabilizer Bar Bushings

Restore front sway bar support with the Mevotech MK3110 suspension stabilizer bar bushing kit. This kit uses natural rubber bushings to secure the stabilizer bar to the frame and help maintain consistent suspension control on select Chevrolet, Pontiac, and Isuzu applications.

• Part number MK3110
• Suspension stabilizer bar bushing kit for front to frame mounting
• Made from natural rubber with a black finish
• Includes 2 bushings
• Inside diameter: 0.9 in.
• Outside diameter: 1.4 in.
• Width: 1.4 in.
• Height: 1.375 in.
• Length: 1.4 in.

Detailed Product Overview

The Mevotech MK3110 is a front stabilizer bar bushing kit built for frame-mounted sway bar service. Its natural rubber construction is sized for a 0.9-inch inside diameter and a 1.4-inch outside diameter, with a 1.4-inch width and 1.375-inch height. This part number MK3110 is used on front-to-frame stabilizer bar setups for vehicles such as the Chevrolet Chevette, Pontiac Fiero, Pontiac T1000, Isuzu I-Mark, Isuzu Impulse, and Chevrolet LUV when equipped with the specified 24 mm or 15/16 in. bar diameter requirement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 1983-1989 Isuzu Impulse, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger
• Fits 1976-1987 Chevrolet Chevette, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger
• Fits 1984-1987 Pontiac Fiero, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger
• Fits 1981-1987 Pontiac T1000, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger
• Fits 1981-1985 Isuzu I-Mark, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger
• Fits 1979-1982 Chevrolet LUV, front to frame, with 24mm bar diameter or larger; with 15/16in bar diameter or larger

Common Replacement Symptoms

• Front sway bar movement caused by worn rubber bushings
• Clunking or rattling from the front suspension over bumps
• Excessive play at the stabilizer bar mounting point
• Reduced steering response from deteriorated frame bushings
• Noise from dry, cracked, or compressed stabilizer bar bushings

Installation Notes

Verify stabilizer bar diameter before ordering, since this kit is specified for vehicles with a 24 mm bar diameter or larger, or 15/16 in. bar diameter or larger. Confirm front-to-frame mounting location and compare the original bushing dimensions to the listed measurements before installation. For best results, inspect the stabilizer bar and frame contact surfaces for wear before replacing the bushings.

Quality Assurance

Mevotech supplies suspension components for repair applications that require accurate fit and material selection. The MK3110 uses natural rubber construction for the specified front stabilizer bar mounting locations on compatible Chevrolet Chevette, Pontiac Fiero, and related applications.