Mevotech MK6717-2 Alignment Shim - Rear

Mevotech MK6717-2 Rear Alignment Shim

Mevotech MK6717-2 is a full contact alignment shim made from polyethylene for rear toe adjustment. It is used to fine-tune rear suspension geometry on select compact GM and Scion applications, including Chevrolet Cobalt, Saturn Ion, Chevrolet HHR, Pontiac Pursuit, and Scion xA.

Key Features

• Full contact alignment shim for rear toe correction
• Polyethylene construction for consistent fit and placement
• Brown color
• Inside diameter: 2.385 in.
• Outside diameter: 3.822 in.
• Cross-references MOOG Chassis Products K6717-2 for the same application

Detailed Description

Mevotech MK6717-2 is a rear alignment shim used to set toe within the specified adjustment range on compatible vehicles. This shim is built with a full contact design and polyethylene material to provide a precise interface during rear suspension alignment service. It is a direct-fit service part for applications that require rear toe adjustment plus or minus 0.50 degree(s), making it relevant for Chevrolet Cobalt, Saturn Ion, Chevrolet HHR, Pontiac Pursuit, and Scion xA rear alignment work. The MK6717-2 part number is also referenced by MOOG Chassis Products K6717-2.

Vehicle Fitment

• Fits 2005-2008 Chevrolet Cobalt, rear — Toe Adjustment Plus or Minus 0.50 Degree(s)
• Fits 2003-2007 Saturn Ion, rear — Toe Adjustment Plus or Minus 0.50 Degree(s)
• Fits 2006 Chevrolet HHR, rear — Toe Adjustment Plus or Minus 0.50 Degree(s)
• Fits 2005-2006 Pontiac Pursuit, rear — Toe Adjustment Plus or Minus 0.50 Degree(s)
• Fits 2004-2006 Scion xA, rear — Toe Adjustment Plus or Minus 0.50 Degree(s)

Common Uses

• Rear toe correction after suspension service
• Alignment adjustment when rear wheel tracking is out of specification
• Restoring proper rear suspension geometry on Chevrolet Cobalt and Saturn Ion models
• Fine-tuning rear alignment on Chevrolet HHR, Pontiac Pursuit, and Scion xA applications

Installation Notes

Install the shim during rear alignment service and verify toe settings after placement. Confirm the vehicle application, position, and required adjustment range before installation. Use the measured shim dimensions, 2.385 in. inside diameter and 3.822 in. outside diameter, to match the service point on the suspension.

Quality Assurance

Mevotech supplies suspension hardware and alignment components for service applications. MK6717-2 is built as a full contact polyethylene shim for the listed rear fitments and is referenced by an equivalent MOOG chassis part number for the same application.