Mevotech MK7320 Suspension Stabilizer Bar Link Bushing - Front

Front Stabilizer Bar Link Bushing for Dakota and Durango

Restore a tighter front suspension connection with the Mevotech MK7320 suspension stabilizer bar link bushing. Built from natural rubber and shaped to end link applications, this bushing helps maintain sway bar link support on select Dodge Dakota and Dodge Durango front suspension setups.

Compatible with 1997-2004 Dodge Dakota, front, and 1998-2004 Dodge Durango, front, this Mevotech MK7320 part is a direct-fit service component for common front-end suspension repair work.

Key Features

• Brand: Mevotech
• Part number: MK7320
• Suspension stabilizer bar link bushing for front applications
• Natural rubber construction for suspension service use
• Blue finish
• Inside diameter: 0.45 in.
• Outside diameter: 1.21 in.
• Width: 1.21 in.
• Height: 2.02 in.
• Design type: to end link
• Includes hardware

Detailed Description

The Mevotech MK7320 is a suspension stabilizer bar link bushing engineered for front-end service on Dodge Dakota and Dodge Durango models listed below. Its natural rubber material is selected for bushing applications where controlled flex and suspension isolation are needed, while the end-link design supports stabilizer bar connection points in the front suspension. If you are replacing worn sway bar link bushings on a 1997-2004 Dodge Dakota or a 1998-2004 Dodge Durango, MK7320 provides the correct service fit for those applications.

This part cross-references MOOG Chassis Products K7320 and Dorman - Premium RK7320PR for the same application.

What It Helps Address

• Front suspension clunking from worn stabilizer bar link bushings
• Excessive sway bar link movement at the end link connection
• Loose or degraded rubber bushings in the front suspension
• Reduced steering response caused by worn stabilizer bar support components
• Noise and vibration from deteriorated front sway bar hardware

Installation Notes and Tips

Verify the front suspension configuration before installation and compare the original bushing dimensions to the MK7320 specifications. Inspect the stabilizer bar link and surrounding hardware for wear, corrosion, or damage before reassembly. Proper alignment of the bushing at the end link helps ensure correct seating and long-term service performance.

• Fits 1997-2004 Dodge Dakota, front
• Fits 1998-2004 Dodge Durango, front

Quality Assurance

Mevotech suspension components are built for chassis service applications and are cataloged with defined dimensional and fitment data for accurate replacement selection. Confirm part number MK7320 against your vehicle’s front stabilizer bar link bushing requirements before ordering.