Mevotech MK90121 Suspension Stabilizer Bar Link Bushing - Front or Rear

Suspension Stabilizer Bar Link Bushing for OE-Style Fitment

Mevotech MK90121 is a suspension stabilizer bar link bushing made from natural rubber for front and rear applications listed below. It is built for vehicles such as the Hyundai Sonata, Suzuki XL-7, and Geo Metro where stabilizer bar link isolation and secure end-link mounting are needed.

Key Features

• Natural rubber construction for flexible, road-ready suspension isolation
• Black finish
• Design type: to end link
• Inside diameter: 0.395 in.
• Outside diameter: 1.0 in.
• Width: 1.26 in.
• Height: 2.28 in.
• Length: 0.625 in.
• Includes hardware
• Two-bushing design for the listed stabilizer bar link applications

Detailed Description

Mevotech MK90121 is a suspension stabilizer bar link bushing engineered for direct replacement use on select front and rear stabilizer bar link locations. The natural rubber material helps maintain the bushing’s shape while providing the compliance needed at the end link connection point. For shoppers searching for Mevotech MK90121, this part cross-references MOOG Chassis Products K90121 for the same application.

Compatible With 1995-2005 Hyundai Sonata, front; 2002-2006 Suzuki XL-7, front; 1989-2001 Suzuki Swift, front or rear; and other listed applications including Chevrolet Metro, Geo Metro, Geo Tracker, Chevrolet Sprint, Chevrolet Tracker, and Pontiac Firefly. If you are replacing worn stabilizer bar link bushings on a Hyundai Sonata or Suzuki XL-7, MK90121 provides the specified OE-style fitment profile.

Common Problems This Part Addresses

• Clunking or rattling from worn stabilizer bar link bushings
• Excessive play at the sway bar end link connection
• Degraded rubber causing looseness in the suspension linkage
• Noise over bumps from deteriorated front or rear stabilizer bar hardware
• Reduced bushing support at the end link mounting point

Installation Notes and Tips

Verify the vehicle position before installation, since MK90121 is listed for both front and rear applications depending on the vehicle. Compare the original bushing dimensions, including inside diameter, outside diameter, width, height, and length, to confirm proper end-link fitment. Clean the stabilizer bar link contact surfaces before assembly and replace any worn mating components if needed.

Quality Assurance

Mevotech MK90121 is a chassis suspension replacement part with published dimensional specifications and confirmed vehicle fitment data for 1989-2006 applications. Use the listed measurements and fitment table to confirm the correct part for your vehicle before installation.