Mevotech MS10403 Suspension Control Arm Bushing - Front Lower Rearward

Mevotech MS10403 Control Arm Bushing

Mevotech MS10403 is a suspension control arm bushing made from natural rubber for direct replacement service on the front lower rearward position. It is built for the 2003-2010 Saab 9-3 with bracket application and uses the listed dimensions for a precise suspension repair. This Mevotech MS10403 bushing supports a clean OE-style service solution for Saab 9-3 front suspension work.

Key Features

• Natural rubber construction for suspension isolation and control
• One bushing per part number
• Inside diameter: 0.75 in.
• Outside diameter: 3.05 in.
• Length: 4.11 in.
• Front lower rearward position with bracket
• Compatible with 2003-2010 Saab 9-3 front lower rearward applications

Detailed Description

Mevotech MS10403 is a suspension control arm bushing engineered for the front lower rearward location on the Saab 9-3. The natural rubber material helps restore the original bushing interface in the control arm assembly, while the listed 0.75-inch inside diameter, 3.05-inch outside diameter, and 4.11-inch length provide the dimensional reference needed for the correct service part. For shoppers searching for a 2003-2010 Saab 9-3 front lower rearward control arm bushing with bracket, MS10403 is the direct-fit reference to compare against the original component. This part cross-references Delphi TD507W and Dorman - OE Solutions 523-662 for the same application.

Common Repair Uses

• Front suspension clunking from worn control arm bushings
• Excessive play in the front lower rearward control arm mount
• Uneven tire wear related to suspension bushing wear
• Steering looseness caused by deteriorated rubber isolation
• Noise and vibration from a damaged Saab 9-3 front bushing

Installation Notes

Verify the vehicle is a 2003-2010 Saab 9-3 and confirm the front lower rearward position with bracket before installation. Compare the old bushing dimensions and mounting style to Mevotech MS10403 to ensure the correct match. Because this is a suspension control arm bushing, proper pressing and alignment procedures are important after replacement.

Quality Assurance

Mevotech MS10403 is built as a suspension replacement part using natural rubber and published dimensional specifications for accurate fitment verification. Confirm the part number MS10403 against the vehicle application and suspension position before service.