Mevotech MS404308 Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Mevotech MS404308 Rear Stabilizer Bar Bushings

Restore rear sway bar support on your Ford Ranger with the Mevotech MS404308 suspension stabilizer bar bushing kit. This kit includes two black rubber bushings with a 0.5-inch inside diameter and a 2.3-inch outside diameter for rear-to-frame mounting on select 1995-2011 Ford Ranger models.

Built for direct replacement service, the MS404308 is sized for the rear stabilizer bar connection and helps maintain consistent bar location at the frame. It is a practical choice for Ford Ranger rear sway bar bushing replacement when the original rubber bushings are worn, cracked, or compressed.

Key Features

• Mevotech suspension stabilizer bar bushing kit, part number MS404308
• Includes 2 rubber bushings
• Black rubber construction
• 0.5-inch inside diameter
• 2.3-inch outside diameter, 2.3-inch width, 2.3-inch height
• Rear to frame application for select Ford Ranger trucks

Detailed Description

The Mevotech MS404308 is a rear stabilizer bar bushing kit for the Ford Ranger, covering 1995-2011 models in the rear-to-frame position. These rubber bushings support the stabilizer bar where it mounts to the frame, helping keep the bar centered and properly isolated at the attachment point. If you are searching for a Ford Ranger rear sway bar bushing kit or a Mevotech MS404308 replacement, this part matches the listed dimensions and application.

This part cross-references MOOG Chassis Products K201284 for the same application.

What It Helps Address

• Clunking or knocking from the rear suspension area
• Excessive play at the rear stabilizer bar mount
• Cracked, flattened, or deteriorated sway bar bushings
• Loose-feeling rear bar support on Ford Ranger trucks
• Noise caused by worn rear-to-frame stabilizer bar isolation

Installation Notes and Tips

• Verify the rear-to-frame position before ordering.
• Confirm the stabilizer bar diameter and bushing dimensions match the listed 0.5-inch inside diameter and 2.3-inch outside diameter.
• Inspect the stabilizer bar and frame mounting surfaces for wear before installation.
• Replace bushings in pairs to maintain even support across the rear stabilizer bar.

Quality Assurance

Mevotech suspension components are cataloged for direct-fit chassis service, and the MS404308 is listed with confirmed Ford Ranger fitment for 1995-2011 rear-to-frame applications.