Mevotech MS40468 Suspension Control Arm Bushing - Front Lower Forward

Mevotech MS40468 Suspension Control Arm Bushing

Mevotech MS40468 is a press-in suspension control arm bushing made from natural rubber with a black finish. It is built for the front lower forward position on select Ford Probe models, helping restore proper suspension joint support in a direct-fit service part.

Key Features

• Natural rubber construction for suspension isolation and compliance
• Press-in mounting type for service replacement applications
• Black finish with a 1.9 in. length
• Inside diameter: 0.64 in.; outside diameter: 2.36 in.
• One bushing included
• Fits 1993-1997 Ford Probe, front lower forward

Application Details

This Mevotech MS40468 suspension control arm bushing is specified for the front lower forward position on 1993-1997 Ford Probe models. If you are replacing a worn Ford Probe front lower forward control arm bushing, MS40468 provides the correct press-in style and dimensions for this application. This part cross-references MOOG Chassis Products K200700 for the same application.

Common Problems It Can Address

• Excessive suspension play at the control arm pivot point
• Clunking or knocking from the front suspension
• Uneven tire wear caused by worn bushing support
• Loose or imprecise steering feel on Ford Probe front suspension
• Cracked, hardened, or deteriorated rubber bushing material

Installation Notes

MS40468 uses a press-in mounting design, so proper bushing service tools and correct control arm support are important during installation. Inspect the control arm and surrounding suspension components for wear before reassembly, and verify the front lower forward position on the vehicle before ordering. Confirm fitment for 1993, 1994, 1995, 1996, and 1997 Ford Probe applications.

Quality Assurance

Mevotech supplies suspension service parts for repair applications, and MS40468 is built to match the listed dimensions and fitment for the specified Ford Probe models. Verify part number MS40468 against the vehicle’s suspension configuration before installation.