Mevotech MS408117 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Mevotech MS408117 Stabilizer Bar Bushing Kit

The Mevotech MS408117 stabilizer bar bushing kit is a suspension service part built with black rubber bushings for restoring sway bar support. With a 1.5 in inside diameter, 1.9 in outside diameter, and a 2-piece set, it is sized for direct replacement work on the stabilizer bar mounting points.

Key Features

• Rubber construction for suspension bushing service
• Black finish
• Inside diameter: 1.5 in
• Outside diameter: 1.9 in
• Height: 2.27 in
• Length: 1.67 in
• Includes 2 bushings

Product Details

Mevotech MS408117 is a suspension stabilizer bar bushing kit used to replace worn sway bar bushings and restore proper bar support at the chassis mounting point. This part cross-references MOOG Chassis Products K200887 and is also listed under OE numbers 5C3Z5484DA and 19459352 for the same application. For buyers searching for Ford and Chevrolet suspension bushing replacement parts, MS408117 provides the specified rubber dimensions needed for a precise service match.

What It Helps Address

• Clunking or rattling from worn stabilizer bar bushings
• Excess sway bar movement at the frame mount
• Loose-feeling front or rear suspension response
• Noise caused by hardened, cracked, or flattened rubber bushings
• Uneven stabilizer bar support during cornering

Installation Notes

Verify stabilizer bar diameter and bushing dimensions before installation. Clean the mounting surface and inspect the sway bar bracket area for wear or corrosion before installing the new bushings. Confirm the application against the vehicle’s suspension layout and part measurements for Ford and Chevrolet service work.

Quality Assurance

Mevotech suspension components are built for replacement service in chassis applications, and this kit follows the listed dimensions and material specifications for MS408117. Confirm fitment by part number and measurements before purchase.