Mevotech MS40967 Steering Pitman Arm - Front

Steering Pitman Arm for Ford Ranger

Restore steering linkage geometry with the Mevotech MS40967 steering pitman arm. This front steering component is built for 1983-1997 Ford Ranger applications and uses a 28-spline connection with a 5.039-inch length for the specified fitment.

Key Features

• Part number: MS40967
• Steering pitman arm for front application
• 28-spline design
• 5.039-inch length
• Fits 1983-1997 Ford Ranger, front
• Cross-references Delphi TA5952 and MOOG Chassis Products K8754 for the same application

Product Details

The Mevotech MS40967 is a steering pitman arm for Ford Ranger front steering systems. It connects the steering gear to the center link and helps transfer steering input through the linkage. With a 28-spline interface and 5.039-inch length, this part is specified for 1983-1997 Ford Ranger models and is a direct-fit replacement for the listed application. If you are searching for a Ford Ranger steering pitman arm, MS40967 provides the fitment and dimensions needed for the correct steering linkage setup.

Common Problems This Part Can Address

• Excessive steering play from a worn pitman arm
• Loose or inconsistent steering response
• Steering linkage movement caused by spline wear
• Front-end steering geometry issues after component wear
• Need for a replacement on 1983-1997 Ford Ranger front steering systems

Installation Notes and Tips

Verify spline count and arm length before installation to confirm the correct steering pitman arm for your vehicle. Inspect related steering linkage components, including the center link and tie rod ends, for wear before completing the repair. Proper alignment should be checked after steering component replacement.

Quality Assurance

Mevotech supplies chassis and steering components for service replacement applications. MS40967 is built to match the listed fitment and dimensional requirements for the specified Ford Ranger steering application.