Mevotech MS50064 Alignment Caster / Camber Bushing - Front

Mevotech MS50064 Alignment Bushing

Mevotech MS50064 is an adjustable alignment caster/camber bushing for front suspension applications that need precise geometry correction. With a 0.78 inside diameter, 1.5 outside diameter, and adjustable design, it provides a direct way to fine-tune camber and caster on a wide range of classic trucks and SUVs.

Compatible With Ford Bronco, Ford F-100, Ford F-150, Ford F-250, Jeep CJ5, Jeep CJ7, Jeep Cherokee, Jeep Wagoneer, Chevrolet K5 Blazer, and Dodge W-series front suspension applications that call for caster/camber adjustment. This part cross-references Gates 23010 for the same application.

Key Features

• Adjustable caster/camber bushing for front suspension alignment correction
• 0.78 inside diameter and 1.5 outside diameter
• Supports plus or minus 1.25 degrees of camber and/or caster adjustment
• Mevotech MS50064 part number for easy catalog matching
• Cross-reference: Gates 23010

Detailed Description

Mevotech MS50064 is built for front-end alignment service on vehicles that use caster/camber bushings to correct suspension geometry. It is a practical solution when front tire wear, steering pull, or alignment readings indicate the need for adjustment. This bushing is listed for a broad range of Ford, Jeep, Chevrolet, GMC, and Dodge applications, including Ford Bronco, Jeep CJ7, Chevrolet K5 Blazer, and Dodge Ramcharger front suspension setups. The adjustable design allows alignment correction within the specified range without changing the overall suspension layout.

What It Helps Address

• Uneven or accelerated front tire wear from incorrect camber or caster
• Steering pull caused by front alignment angles outside specification
• Front-end alignment readings that need fine adjustment after service
• Suspension geometry correction on lifted or restored classic trucks and SUVs
• Front wheel tracking issues on vehicles with adjustable bushing alignment systems

Installation Notes and Tips

Install MS50064 in the front suspension at the alignment point specified for the vehicle. After installation, perform a professional wheel alignment and verify camber and caster settings against factory specifications. Confirm the required bushing dimensions and application before ordering, especially on older Ford Bronco, Jeep CJ, Chevrolet K-series, and Dodge W-series platforms. The part number MS50064 should be matched to the vehicle’s front suspension design and alignment requirements.

Quality Assurance

Mevotech MS50064 is an adjustable alignment component built for service on a wide range of classic front suspension applications. Its cataloged dimensions, adjustment range, and vehicle-specific fitment data support accurate part selection for alignment repair work.