Mevotech MS50202 Alignment Cam Bolt Kit - Front

Alignment Cam Bolt Kit for Front Suspension

Mevotech MS50202 is a front alignment cam bolt kit built for camber adjustment on a range of import and domestic vehicles. It uses a hexagonal bolt head, black finish, and M12 x 1.75 thread size to support precise front suspension alignment service.

Compatible With front-end alignment work on vehicles such as the Buick Encore, Acura CSX, and Audi Cabriolet, this kit is used where camber correction is needed during suspension repair or alignment setup. The MS50202 part number is also referenced in cross applications for the same type of service.

Key Features

• Brand: Mevotech
• Part number: MS50202
• Alignment cam bolt kit for front suspension use
• Camber adjustment type
• Hexagonal bolt head for standard service tools
• Black finish
• Nut included
• Bolt length: 2.74
• Thread size: M12 - 1.75

Detailed Description

Mevotech MS50202 is an alignment cam bolt kit used to adjust front camber during suspension alignment procedures. The cam-style design allows technicians to fine-tune wheel angle settings after suspension work, collision repair, or component replacement. This part is listed for front applications on vehicles including the 2013-2017 Buick Encore, 2006-2010 Acura CSX, and 1994-1998 Audi Cabriolet, with fitment coverage spanning 46 vehicle applications across the listed years.

This part cross-references MOOG Chassis Products K90474 for the same application. It is also associated with interchange numbers 699.64004 and 2643642.

What It Helps Address

• Front camber out of specification after suspension service
• Alignment correction after strut, control arm, or knuckle replacement
• Uneven tire wear caused by incorrect front camber settings
• Steering pull related to front suspension geometry
• Need for camber adjustment on vehicles with listed front fitment

Installation Notes and Tips

• Install on the front suspension only where the vehicle listing specifies front fitment.
• Verify thread size and bolt length before installation: M12 - 1.75 and 2.74.
• Use proper alignment equipment after installation to set camber to specification.
• Confirm vehicle-specific notes, including the 14mm bolt and plus or minus 1.75 degrees camber note shown in the fitment data.
• Follow factory torque procedures and alignment specifications for the exact vehicle application.

Quality Assurance

Mevotech suspension hardware is built for service use in alignment and chassis repair applications. MS50202 is specified with defined bolt head type, thread size, finish, and fitment data to support accurate parts selection for front camber adjustment service.