Mevotech MS868151 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Mevotech MS868151 Stabilizer Bar Bushings

Restore front suspension control with the Mevotech MS868151 suspension stabilizer bar bushing kit. This rubber bushing set is built for front-to-frame applications on select Toyota and Scion vehicles, helping maintain proper sway bar location and reduce unwanted movement at the chassis mount.

• Rubber construction for front stabilizer bar mounting support
• Black finish with 2 bushings included
• Inside diameter: 0.984 in.
• Dimensions: 2.432 in. length, 2.041 in. width, 2.05 in. height
• Direct fit for front-to-frame applications on select Toyota RAV4, Toyota Prius V, and Scion xB models
• Mevotech MS868151 cross-references MOOG Chassis Products K201279 and K201483 for the same application

Fitment Details

• Fits 2008-2015 Scion xB, Front To Frame
• Fits 2012-2015 Toyota Prius V, Front To Frame
• Fits 2006-2014 Toyota RAV4, Front To Frame

Built for the front stabilizer bar-to-frame location, this Mevotech MS868151 kit helps secure the sway bar bushing interface where wear commonly develops from age, road exposure, and repeated suspension movement. It is a practical replacement for drivers searching for a front sway bar bushing kit for Toyota RAV4, Toyota Prius V, or Scion xB models, and it supports consistent bar positioning at the frame mount. The Mevotech MS868151 part number is also a useful reference when comparing OE-style replacement options for these applications.

Common Problems This Part Addresses

• Clunking or knocking from the front suspension area
• Excess sway bar movement at the frame mount
• Worn, cracked, or flattened stabilizer bar bushings
• Loose-feeling front-end response over bumps and turns
• Noise caused by deteriorated rubber bushing material

Installation Notes and Tips

Confirm the vehicle’s front-to-frame stabilizer bar location before ordering. Inspect the sway bar, mounting brackets, and surrounding hardware for wear or corrosion during replacement, and compare the original bushing dimensions to the listed measurements for proper fit. The kit includes 2 bushings.

Quality Assurance

Mevotech suspension components are built for replacement use in chassis service applications. Verify fitment by year, make, model, and position before installation to ensure the correct front stabilizer bar bushing match for your vehicle.