Mevotech TXMS30606 Steering Tie Rod End - Front Right Outer

Steering Tie Rod End for Heavy-Duty Front Right Service

Mevotech TXMS30606 is a front right outer steering tie rod end built for demanding use on select Nissan and INFINITI trucks and SUVs. It is engineered with a pre-greased, greaseable design and a sintered metal bearing for consistent steering response in high-mileage and high-load applications.

Compatible With 2004-2024 Nissan Armada, 2004-2015 Nissan TITAN, 2004-2013 INFINITI QX56, 2014-2024 INFINITI QX80, and 2004 Nissan Pathfinder Armada, front right outer.

Key Features

• Part number TXMS30606 for front right outer steering service
• Pre-greased and greaseable for maintenance-friendly operation
• Sintered metal bearing material for durable steering joint performance
• Neoprene dust boot with improved seal protection
• Includes castle nut, cotter pin, grease fitting, dust boot, and mounting hardware
• Threaded stud design with M14 x 1.5 end thread size
• Non-adjustable design for direct replacement use

Built for Demanding Steering Applications

Mevotech TTX tie rod ends are engineered for commercial vehicles, passenger vehicles, SUVs, fleets, and working trucks that see frequent steering loads. TXMS30606 uses a threaded stud, male-to-female end configuration, and a green dust boot to support long-term service in the front right outer steering position. The Mevotech TXMS30606 is a direct-fit steering tie rod end for select Armada, TITAN, QX56, and QX80 applications where precise steering linkage replacement is required.

This part cross-references MOOG Chassis Products ES800032 and Delphi TA3057 for the same application.

Common Problems This Part Can Address

• Loose or wandering steering feel at the front right wheel
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Damaged dust boot or loss of grease retention at the joint
• Steering response issues from a worn sintered bearing surface

Installation Notes and Tips

Verify front right outer placement before installation and confirm thread size, stud length, and end configuration against the removed part. After replacement, a professional wheel alignment is recommended to restore steering geometry. The included grease fitting allows routine lubrication during service intervals.

Quality Assurance

Mevotech TTX components are built for high-usage steering applications and use labor-saving design elements to simplify service. TXMS30606 is engineered for durability and consistent operation in demanding truck and SUV use.