Mevotech TXMS406141 Steering Tie Rod End - Front Right Outer

Mevotech TTX Tie Rod End for Transit Connect

The Mevotech TTX TXMS406141 steering tie rod end is built for demanding front-end service on the Ford Transit Connect. It combines a greaseable, self-lubricating sintered metal bearing with a sealed boot design to support precise steering response and long service life in high-use driving conditions.

Compatible with 2020-2023 Ford Transit Connect front right outer applications, this part is a direct-fit steering component for commercial vans, passenger use, fleets, and working trucks. The TXMS406141 is also identified by OE cross-reference numbers 19472738 and KV6Z3A130A for the same application.

• Mevotech TTX steering tie rod end for front right outer placement
• Greaseable, self-lubricating sintered metal bearing
• Green boot with superior seal protection
• Castle nut included
• Cotter pin included
• Engineered for high-usage Ford Transit Connect steering service

Built for Steering Precision

TXMS406141 is part of Mevotech’s TTX line, which focuses on heavy-duty steering and suspension service for vehicles that see frequent use. For the Ford Transit Connect, this tie rod end helps restore steering linkage integrity at the front right outer position while supporting consistent articulation and reduced wear under repeated load cycles. If you are searching for a Ford Transit Connect front right outer tie rod end or a Mevotech TXMS406141 replacement, this part matches the listed application.

Common Problems It Can Address

• Loose or vague steering feel
• Front-end play caused by worn tie rod end joints
• Uneven tire wear linked to steering linkage wear
• Boot damage that exposes the joint to contamination
• Noise or clunking from worn outer steering components

Installation Notes

Install on 2020-2023 Ford Transit Connect front right outer steering positions only. Verify alignment after replacement, and inspect the mating steering components for wear before returning the vehicle to service. The included castle nut and cotter pin support a proper mechanical fastening setup during installation.

Quality Assurance

Mevotech TTX parts are engineered for demanding steering applications with durable materials and service-friendly design details. The TXMS406141 uses a sintered metal bearing and sealed boot protection to support long-term performance in commercial and passenger vehicle use.