Mevotech TXMS60843 Suspension Stabilizer Bar Link Kit - Rear Left

Rear Left Stabilizer Bar Link for Honda CR-V

Restore rear suspension connection and steering response with the Mevotech TXMS60843 stabilizer bar link kit. This rear left link is built for 2007-2016 Honda CR-V applications and uses ball joint ends, greaseable sintered metal bearings, and a pre-greased design for serviceable operation.

Mevotech TXMS60843 is a direct-fit rear stabilizer bar link kit for the Honda CR-V, with threaded studs, dust boot protection, and included locking nuts and hardware for the specified position.

Key Features

• Fits 2007-2016 Honda CR-V, rear left
• Suspension stabilizer bar link kit for the rear suspension
• Ball joint ends on both sides for articulation
• Pre-greased and greaseable for maintenance access
• Sintered metal bearing material for serviceable wear surfaces
• Dust boot included for added joint protection
• Threaded stud design with locking nuts included
• Hardware included for the listed application
• Length: 3.35 in.

Detailed Description

The Mevotech TXMS60843 rear stabilizer bar link connects the sway bar to the suspension on the rear left side of the Honda CR-V. It uses ball joint ends and sintered metal bearings to support smooth movement at the link while maintaining a secure connection under normal suspension travel. The greaseable design and included grease fittings allow periodic servicing, while the dust boot helps protect the joint area from contamination.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. For shoppers searching for a rear left sway bar link for 2007-2016 Honda CR-V, Mevotech TXMS60843 provides the specified fitment and serviceable construction.

Common Problems This Part Can Address

• Clunking or rattling from the rear suspension
• Loose or worn stabilizer bar link joints
• Excess sway-bar movement over bumps and turns
• Noise caused by damaged dust boots or worn bearing surfaces
• Reduced rear suspension stability from a failed link

Installation Notes and Tips

Install TXMS60843 on the rear left position only for the listed Honda CR-V fitment. Verify the existing link length, stud style, and mounting orientation before removal, and torque the locking nuts to the vehicle manufacturer’s specification. Because this link is greaseable, service the fittings after installation and during routine chassis maintenance.

Quality Assurance

Mevotech supplies suspension components with serviceable designs that emphasize wear protection and maintenance access. TXMS60843 includes pre-greased joints, grease fittings, a dust boot, and sintered metal bearings for the specified rear left Honda CR-V application.