Monroe 172951 Suspension Strut and Coil Spring Assembly - Front Left

Monroe Quick-Strut for Jeep Compass and Patriot

Restore front suspension height and ride control with the Monroe Quick-Strut Complete Strut Assembly, part number 172951. This vehicle-specific front left assembly is built for 2011-2017 Jeep Patriot and 2012-2017 Jeep Compass applications, with a complete preassembled design that simplifies OE-style replacement.

Key Features

• Complete front left suspension strut and coil spring assembly
• Vehicle-specific fit for Jeep Compass and Jeep Patriot applications
• Engineered to restore factory ride height and ride performance
• Gas charged for consistent suspension response
• Includes mounting hardware
• Assembled in Paragould, Arkansas
• Compressed length: 13.44 in.; extended length: 17.57 in.; travel length: 4.13 in.

Product Details

Monroe Quick-Strut assemblies are fit checked and ride tested to match the application-specific requirements of the vehicle. Part number 172951 combines the strut, coil spring, and related components into a single front left unit for 2012-2017 Jeep Compass and 2011-2017 Jeep Patriot models. This Monroe Quick-Strut Complete Strut Assembly is built to support direct replacement service where a complete OE-style suspension strut and coil spring assembly is needed. This part cross-references Focus Auto Parts 1333508L for the same application.

What It Helps Address

• Front-end sag from a worn strut and spring assembly
• Excessive bounce or reduced damping control
• Noisy or uneven suspension operation at the front left corner
• Loss of factory ride height after component wear
• Time-consuming rebuilds of individual strut components

Installation Notes and Tips

Fits 2012-2017 Jeep Compass, front left. Fits 2011-2017 Jeep Patriot, front left. Verify the vehicle’s front left suspension configuration before installation and compare the removed assembly to the new unit for length and mounting alignment. Because this is a complete strut and coil spring assembly, it is suited to replacement of the full corner assembly rather than individual internal parts.

Quality Assurance

Monroe states that Quick-Strut assemblies are fit checked and ride tested, with application-specific engineering aimed at restoring factory ride height and ride performance. The assembly is produced in Paragould, AR, and built as a single-unit replacement for the listed Jeep applications.