Monroe 37240 Shock Absorber - Rear

Monroe OESpectrum Rear Shock for Sequoia

The Monroe OESpectrum Light Truck Shock Absorber, part number 37240, is built for rear suspension service on the 2001-2007 Toyota Sequoia without Automatic Leveling System. It is aimed at restoring factory-style drivability with controlled handling and reduced noise, vibration, and harshness.

For Toyota Sequoia rear shock replacement, Monroe 37240 provides OE-style ride control with dimensions and mounting details matched to the application. This part cross-references KYB 344358 and 3440068 for the same application.

Key Features

• Rear suspension shock absorber for 2001-2007 Toyota Sequoia without Automatic Leveling System
• Monroe OESpectrum Light Truck Shock Absorber line for light truck and SUV ride control
• Compressed length: 14.875 in.; extended length: 24 in.; travel length: 9.125 in.
• Metal dust shield included for added protection
• Upper mount: stem mount, 2.5/8 in. stem length, 1/2 in.-13 thread pitch
• Lower mount: loop bushing and sleeve mount with 3/4 in. sleeve ID and 1.3/4 in. sleeve OAL
• Extended bumper stop: yes

Product Details

Monroe’s OESpectrum Light Truck Shock Absorber line focuses on restoring original factory drivability while improving control over body motion and road input. On the Toyota Sequoia rear suspension, Monroe 37240 is specified as an OE application-specific replacement with the correct mounting style, stroke length, and overall dimensions for the listed fitment.

Use Monroe 37240 when replacing a worn rear shock on a 2001-2007 Toyota Sequoia. The design helps maintain stable rear suspension response, supports consistent tire contact, and filters harshness that can come through the chassis on rough pavement.

What It Helps Address

• Excessive rear bounce after bumps
• Loose or unsettled rear-end handling
• Noise and vibration from worn shock internals
• Harsh ride quality over uneven roads
• Reduced control during load changes or braking

Installation Notes and Tips

Fits 2001-2007 Toyota Sequoia, rear, without Automatic Leveling System. Verify the upper stem mount and lower loop bushing and sleeve mount before installation. Confirm compressed and extended lengths against the original shock to ensure proper suspension travel and fitment on the vehicle.

For Toyota Sequoia rear shock absorber replacement, Monroe 37240 should be matched to the non-leveling suspension configuration only. Check the existing hardware condition and mounting points during service so the replacement shock seats correctly and operates through full suspension travel.

Quality Assurance

Monroe OESpectrum shocks are built as OE-style replacement components for application-specific fitment and ride control. Part number 37240 is engineered for the listed Toyota Sequoia rear application and follows Monroe’s light truck shock absorber design standards.