Moog CK80722 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

OE-Style Front Right Upper Control Arm

The Moog CK80722 is a suspension control arm and ball joint assembly for the front right upper position on select Ford, Mercury, and Explorer Sport Trac applications. Built with stamped steel construction and a pre-greased design, it is aimed at heavier-duty use where road impact and load demand more from the suspension.

Fits 2006-2010 Ford Explorer, front right upper; fits 2007-2010 Ford Explorer Sport Trac, front right upper; fits 2006-2010 Mercury Mountaineer, front right upper.

• Moog CK80722 suspension control arm and ball joint assembly
• Stamped steel control arm with black finish
• Pre-greased for initial service readiness
• Rubber bushings included for suspension mounting points
• Press-in ball joint mounting type with threaded ball joint stud
• Mounting hardware included
• Non-adjustable design for direct replacement use

Built For Heavier Suspension Demands

Moog High Utilization Designs are engineered for vehicles that see tougher roads and higher load conditions. On the Ford Explorer, Ford Explorer Sport Trac, and Mercury Mountaineer, the CK80722 helps restore upper control arm function at the front right corner while maintaining the geometry needed for stable steering response and consistent suspension movement. This part cross-references Dorman OE Solutions 521-356 for the same application.

Common Issues This Part Can Address

• Excessive front-end looseness or wandering
• Clunking or knocking from the upper suspension area
• Worn rubber bushings affecting ride control
• Ball joint wear at the front right upper control arm
• Uneven tire wear related to suspension play

Installation Notes And Tips

Verify vehicle year, make, model, and front right upper position before installation. Because this assembly uses a press-in ball joint and threaded stud, proper suspension service tools and alignment procedures are recommended after replacement. Inspect adjacent steering and suspension components during service to confirm the repair addresses the full source of wear.

Quality Assurance

Moog suspension components are built around OE-style fitment and service-focused construction. The CK80722 uses stamped steel, included bushings, and a pre-greased design to support dependable replacement performance in demanding driving conditions.