Moog K200131 Suspension Stabilizer Bar Bushing Kit - Rear To End Link

Moog K200131 Sway Bar Bushing Kit

Restore rear stabilizer bar support with the Moog K200131 suspension stabilizer bar bushing kit. This rubber sway bar bushing is built for a 0.750-inch bar diameter and is engineered to exceed OE manufacturer specs for a precise, durable replacement.

Compatible with 1995-2001 Chevrolet Lumina and 1995-1999 Chevrolet Monte Carlo rear to end link applications, this Moog K200131 bushing kit supports stable sway bar movement and consistent chassis control. It is a direct-fit solution for drivers searching for a rear sway bar bushing for Chevrolet Lumina or Chevrolet Monte Carlo rear end link service.

Key Features

• Rubber construction for suspension isolation and bar support
• 0.750-inch inner diameter for 20mm sway bar applications
• 0.750-inch bar diameter specification
• Split-design style noted for easier installation on listed applications
• Exceeds OE manufacturer specifications
• Designed for rear to end link mounting locations
• Cross-reference part number: HB200131

Detailed Description

The Moog K200131 sway bar bushing kit is a replacement stabilizer bar bushing designed to maintain proper rear sway bar positioning and reduce unwanted movement at the end link connection. With a 1.400-inch outer diameter, 1.260-inch length, and rubber material construction, it is built for the listed Chevrolet Lumina and Chevrolet Monte Carlo rear applications where a 20mm sway bar diameter is specified. Moog’s chassis-focused engineering emphasizes design updates that improve service life and simplify replacement, making this part a practical choice for suspension repair.

This part number, K200131, is a fitment-specific solution for Chevrolet Lumina and Chevrolet Monte Carlo rear stabilizer bar service. If you are replacing worn rear sway bar bushings on these vehicles, K200131 provides the correct bar diameter match and OE-plus specification target for the application.

Common Problems This Part Helps Address

• Clunking or rattling from the rear stabilizer bar area
• Excessive sway bar movement at the end link connection
• Worn, cracked, or compressed rubber bushings
• Loose-feeling rear suspension response during cornering
• Noise caused by deteriorated sway bar support points

Installation Notes and Tips

• Verify the rear sway bar diameter is 20mm before installation.
• Confirm the vehicle application matches the listed rear to end link position.
• Inspect the sway bar and end link surfaces for wear before installing the new bushings.
• Split-design bushings can simplify installation on the listed applications.
• Hardware is not included.

Quality Assurance

Moog is known for chassis components that incorporate design improvements aimed at extending service life and simplifying replacement. The K200131 is engineered to exceed OE manufacturer specifications for the listed applications.