Moog K5332 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Front Sway Bar Bushing Kit for OE-Style Control

Restore front suspension stability with the MOOG K5332 suspension stabilizer bar bushing kit. This thermoplastic sway bar bushing is built for front-to-frame applications and matches the 34 mm sway bar diameter used on select Buick, Oldsmobile, Pontiac, and Cadillac models.

MOOG is known for chassis parts that focus on longer service life and easier replacement, and this K5332 sway bar bushing follows that approach with OE-spec fitment that exceeds original manufacturer requirements.

Key Features

• Thermoplastic construction for consistent bushing support
• 1.330 in inner diameter and 1.860 in outer diameter
• 1.560 in length for front sway bar mounting applications
• Designed for 34 mm sway bar diameter fitment
• Meets and exceeds OE manufacturer specs
• Fits front to frame suspension locations
• Compatible with select Buick LeSabre, Oldsmobile 88, Pontiac Bonneville, and Cadillac DeVille applications

Detailed Description

The MOOG K5332 is a suspension stabilizer bar bushing kit made for front sway bar mounting points where the bar attaches to the frame. It is engineered for vehicles with a 34 mm sway bar diameter, including 1986-1999 Buick LeSabre, 1992-1999 Oldsmobile 88, 1987-1999 Pontiac Bonneville, and several Cadillac and Oldsmobile full-size platforms. This part cross-references Mevotech Supreme MK5332 for the same application.

Use MOOG K5332 when replacing worn sway bar bushings on vehicles such as the Buick LeSabre, Oldsmobile 98, and Pontiac Bonneville. The thermoplastic material helps maintain a secure bar-to-frame interface, supporting more consistent front suspension response and reducing unwanted movement at the stabilizer bar mount.

What This Part Helps Address

• Clunking or knocking from the front sway bar area
• Excessive sway bar movement at the frame mount
• Loose or deteriorated stabilizer bar bushings
• Reduced front-end stability during cornering
• Noise caused by worn suspension bushings

Installation Notes and Tips

Verify the sway bar diameter before installation; this part is specified for a 34 mm bar. Inspect the mounting surface and surrounding hardware for wear, corrosion, or deformation before fitting the new bushings. Because hardware is not included, reuse or replace mounting components as needed based on condition. Confirm the front-to-frame position and vehicle application before service.

Quality Assurance

MOOG designs chassis components with product-life improvements and installation-focused updates, and this bushing kit is specified to exceed OE manufacturer requirements. Part number K5332 is built for direct replacement use on the listed applications.