Moog RK622314 Suspension Control Arm and Ball Joint Assembly - Rear Right Upper Forward

Overview

MOOG RK622314 is a suspension control arm and ball joint assembly built for structural strength and corrosion protection. It is a direct-fit replacement for select BMW rear suspension applications and uses an aluminum arm with a press-in ball joint and rubber bushings.

Key Features

• Aluminum control arm construction for a lightweight, rigid design.
• Press-in ball joint with threaded stud for secure assembly.
• Rubber bushings included for suspension isolation.
• No grease fitting for a sealed, low-maintenance design.
• Engineered to meet OEM standards for the listed applications.

Detailed Description

This MOOG suspension control arm and ball joint assembly, part number RK622314, is built for BMW applications that require a rear right upper forward control arm. The aluminum construction supports structural strength while the corrosion-protection focus helps the part stand up to everyday road exposure. With bushings included, a press-in ball joint, and a threaded stud design, RK622314 is configured as a replacement assembly for restoring suspension geometry and joint integrity. This part cross-references Beck/Arnley 102-7120 and Dorman - OE Solutions 522-193 for the same application.

Compatible With BMW 650i, 750i, 750Li, 760Li, and Alpina B7 applications listed for the rear right upper forward position. Use RK622314 when replacing a worn BMW suspension control arm and ball joint assembly on the specified models.

What It Is Used For

• Correcting looseness or play in the suspension linkage.
• Replacing a worn or damaged control arm assembly.
• Addressing noise from deteriorated bushings or ball joint wear.
• Restoring suspension alignment stability after component wear.
• Repairing corrosion-affected suspension hardware in the listed application.

Installation Notes and Tips

Verify the vehicle application, position, and suspension configuration before installation. Because this assembly uses a press-in ball joint and included bushings, inspect the surrounding mounting points and related hardware for wear or damage during service. Follow factory service procedures for torque and alignment checks after installation.

Quality Assurance

MOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and corrosion protection. RK622314 is specified to meet OEM standards for the listed BMW applications.