Moog RK80722 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

Moog RK80722 Front Right Upper Control Arm

Moog RK80722 is a front right upper suspension control arm and ball joint assembly for select Ford, Mercury applications. Built with stamped steel construction, rubber bushings, and a pre-greased design, it is engineered for structural strength and corrosion protection in daily driving conditions.

Key Features

• Part number RK80722 for direct identification
• Fits 2006-2010 Ford Explorer, front right upper
• Fits 2007-2010 Ford Explorer Sport Trac, front right upper
• Fits 2006-2010 Mercury Mountaineer, front right upper
• Stamped steel control arm with black finish
• Pre-greased assembly with rubber bushings installed
• Press-in ball joint with threaded stud type
• Mounting hardware included
• No grease fitting included

Product Details

This Moog control arm assembly is built for the front right upper suspension position on the Ford Explorer, Ford Explorer Sport Trac, and Mercury Mountaineer. RK80722 uses stamped steel for the arm body, rubber for the bushings, and a press-in ball joint design to match the service requirements of the listed vehicles. The assembly is pre-greased and finished in black for added corrosion resistance. This part cross-references Dorman OE Solutions 521-356 for the same application.

Common Repair Uses

• Clunking or knocking from the front suspension
• Excessive play in the upper control arm or ball joint
• Uneven tire wear related to worn suspension geometry
• Steering looseness or wandering at the front end
• Failed bushings or ball joint wear on the right upper control arm

Installation Notes

Install RK80722 in the front right upper position only on the listed Ford Explorer, Explorer Sport Trac, and Mercury Mountaineer applications. Verify alignment after replacement, since upper control arm service can affect camber and caster settings. Confirm the press-in ball joint and threaded stud interface match the vehicle’s suspension layout before installation.

Quality Assurance

Moog premium control arms are engineered for structural strength and corrosion protection on foreign and domestic nameplates. RK80722 is built to OE-style service expectations for the specified fitments and is backed by Moog’s product quality standards.