Mopar 68304271AA Drive Axle Shaft Seal

Mopar Drive Axle Shaft Seal for Wrangler

This Mopar drive axle shaft seal is a direct-fit sealing component for the rear axle application on 2013-2017 Jeep Wrangler models. It helps maintain proper axle lubrication and supports clean, reliable driveline operation in daily driving and off-road use.

Key Features

• Genuine Mopar part number 68304271AA
• Drive axle shaft seal for the axle sealing system
• Fits 2013-2017 Jeep Wrangler, N/A
• Supersedes part number 05014852AC
• OE-style replacement for factory sealing service

Detailed Description

Part number 68304271AA is a Mopar drive axle shaft seal used in the driveline and axle sealing system on Jeep Wrangler vehicles from 2013 through 2017. This seal is specified for the N/A position listed in the fitment data and is intended for service work where the axle shaft seal needs to be replaced to restore sealing integrity. For buyers searching for a Jeep Wrangler axle shaft seal, Mopar 68304271AA provides the correct application match for the listed model years.

What It Helps Address

• Gear oil seepage at the axle shaft seal area
• Contamination entering the axle housing through a worn seal
• Fluid loss that can affect axle lubrication
• Noise or wear concerns related to low axle fluid level
• Service replacement for a damaged or aging Jeep Wrangler seal

Installation Notes and Tips

Verify axle configuration and seal location against the vehicle before installation. Inspect the axle shaft, housing bore, and surrounding sealing surfaces for wear or damage, and replace any compromised components as needed. Proper cleaning of the sealing area and careful seating of the new seal are important for a reliable repair.

Quality Assurance

As a Mopar replacement part, 68304271AA follows OEM application standards for the listed Jeep Wrangler fitment. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.