Motorad 1020-180 Engine Coolant Thermostat Housing Assembly

Integrated Housing Thermostat Assembly

The Motorad 1020-180 integrated housing thermostat is built for direct replacement in select GM applications that require a 180 degree thermostat and housing assembly. It combines the thermostat, housing, and gasket in one service part for a cleaner repair on cooling systems that need precise temperature control.

Compatible With 2010-2015 Chevrolet Camaro, 2013-2015 Cadillac ATS, 2014-2015 Cadillac CTS, 2015-2016 Chevrolet Colorado, and 2015-2016 GMC Canyon applications listed below.

Key Features

• Integrated housing thermostat assembly with thermostat, housing, and gasket included
• 180 degree opening temperature for OE-specified cooling system operation
• Bleeder hole and jiggle pin included for air management during service
• Aluminum, stainless steel, and copper construction
• Silver finish with 3 bolt holes and 2 outlet ports
• Bolts and mounting hardware included
• Metal gasket/seal material for a secure mating surface

Product Details

Motorad Integrated Housing Thermostat line parts are engineered to OE specifications and manufactured using OEM-quality materials and processes. The copper case and wax compound are used to respond quickly to coolant temperature changes, helping the engine reach and maintain the intended operating range. This Motorad 1020-180 thermostat housing assembly is a direct-fit cooling system service part for vehicles that call for a 180F thermostat, including Chevrolet Camaro, Cadillac ATS, Cadillac CTS, Chevrolet Colorado, and GMC Canyon applications.

This part cross-references Dorman OE Solutions 902-2078 and Four Seasons 86005 for the same application.

Common Cooling System Issues

• Engine running too cool or too warm due to thermostat wear
• Coolant leaks at the thermostat housing or gasket surface
• Delayed warm-up after cold starts
• Temperature fluctuation from a sticking thermostat
• Air trapped in the cooling system after thermostat service

Installation Notes

• Verify the vehicle uses a 180 degree thermostat specification before installation.
• Inspect the mating surfaces and coolant passages for corrosion or debris.
• Use the included gasket/seal and hardware as specified for the application.
• Bleed the cooling system carefully after installation to remove trapped air.
• Confirm proper coolant level and operating temperature after service.

Quality Assurance

Manufactured by an OE supplier with OEM-quality materials and safety standards, this thermostat housing assembly is built to meet the demands of modern automotive cooling systems. Motorad part number 1020-180 is produced to OEM specifications for consistent fit and temperature response.