Motorad 4834KTUS Engine Coolant Thermostat Housing Assembly

Engine Coolant Thermostat Housing Assembly

Motorad 4834KTUS is an engine coolant thermostat housing assembly built to OE specifications for temperature control in the cooling system. It is a direct-fit style replacement for select Dodge Neon, Chrysler Neon, Plymouth Neon, Chrysler Cirrus, Dodge Stratus, and Plymouth Breeze applications with a 195°F thermostat setting.

Motorad Kit products focus on complete cooling-system service parts, and this assembly follows that approach with the housing, thermostat, and seal specified for the listed applications. The Motorad 4834KTUS is made with plastic, stainless steel, copper, and rubber components to support reliable coolant flow and consistent thermostat response.

• OE-spec thermostat housing assembly for cooling system service
• 195°F start-to-open temperature for listed applications
• Plastic, stainless steel, copper, and rubber construction
• Black and silver finish
• Mechanical actuator with disk valve type
• Includes gasket/seal where applicable; O-ring seal type
• 2 mounting holes and offset design with air relief valve

Detailed Product Overview

This thermostat housing assembly is manufactured using OEM-quality materials and OE supplier processes to match factory specifications. The copper case and wax compound are used to respond quickly to coolant temperature changes, helping the thermostat regulate engine operating temperature as intended. Motorad 4834KTUS is a practical replacement choice for drivers servicing a 2000-2005 Dodge Neon, 2000-2002 Chrysler Neon, 2000-2001 Plymouth Neon, 2000 Chrysler Cirrus, 2000 Dodge Stratus, or 2000 Plymouth Breeze. This part cross-references Monroe Shocks & Struts (e.g., SUTK4384) for the same application.

What It Helps Address

• Coolant temperature that stays too low or rises above normal range
• Cracked, warped, or leaking thermostat housing
• Failed thermostat response during warm-up or driving
• Coolant seepage at the housing seal or O-ring
• Cooling-system service on OE-specified 195°F applications

Installation Notes

Verify engine code, thermostat temperature, and housing style before installation. Clean the mating surface thoroughly and replace any worn seal surfaces as needed. The housing uses an O-ring seal design and does not include mounting hardware. Confirm the coolant system is properly bled after installation so the air relief feature can function as intended.

Quality Assurance

Motorad manufactures this assembly with OEM-quality materials and safety standards as an OE supplier, using OEM specifications and processes for the listed applications. The design includes an offset layout, air relief valve, and OEM-style seals where applicable to support factory-style cooling-system service.