Motorad 736-194 Engine Coolant Thermostat Housing Assembly

Integrated Housing Thermostat for Ford Cooling Systems

Motorad 736-194 is an integrated housing thermostat assembly built for OE-style cooling system service. It combines the thermostat, housing, and seal in one service part for select Ford Fiesta, Escape, and Fusion applications with a 194°F opening temperature.

The Integrated Housing Thermostat line from Motorad focuses on direct-fit replacement parts that follow OEM specifications and processes. This assembly uses OEM-quality materials, includes an aluminum, stainless steel, and copper construction, and features a copper case with wax compound for quick response to coolant temperature changes.

Key Features

• Part number: 736-194
• Integrated engine coolant thermostat housing assembly
• 194°F opening temperature / start-to-open temperature
• Bleeder hole and jiggle pin included
• Rubber gasket/seal included
• 4 bolt holes for OE-style mounting
• 3 outlet ports with outlet diameters of 1.30 in, 0.80 in, and 0.68 in
• Silver finish
• Offset design with air relief valve where applicable

Detailed Description

Motorad 736-194 is engineered as a direct replacement thermostat housing assembly for cooling system maintenance on 2013-2014 Ford Escape, 2013-2014 Ford Fusion, and 2014-2016 Ford Fiesta. It is built to OE specifications and uses OEM-style seals where applicable to support proper fit and sealing at the coolant outlet. The 194°F calibration is specified for these applications, and the integrated design helps simplify service by combining the thermostat and housing into one assembly.

This part cross-references Dorman - OE Solutions 902-1100 for the same application.

What It Helps Address

• Coolant temperature regulation concerns tied to a worn thermostat
• Leaks at the thermostat housing or seal interface
• Slow thermostat response during warm-up
• Service issues related to a cracked or deteriorated housing
• Fitment problems from non-OE-style replacement parts

Installation Notes and Tips

• Verify the 194°F specification before installation on Ford Fiesta, Escape, or Fusion applications.
• Inspect the mating surfaces and coolant passages for corrosion or residue before assembly.
• Replace coolant as required by the vehicle service procedure after thermostat housing service.
• Confirm the bleeder hole and jiggle pin orientation during installation to support air evacuation.
• Use the correct torque sequence for the 4-bolt housing to help maintain seal integrity.

Quality Assurance

Motorad manufactures this thermostat housing assembly with OEM-quality materials and safety standards as an OE supplier. It is produced to OEM specifications and processes for consistent fit and cooling system performance in the listed Ford applications.