MPA Electrical 1001-0664M Disc Brake Pad Set - Rear

Rear Brake Pads for Ford Windstar

MPA Electrical 1001-0664M is a rear disc brake pad set for 1995-2003 Ford Windstar models. It uses an integrally molded friction material with adhesive-backed pad shims and included abutment clips to support consistent pedal feel and quieter operation.

Key Features

• Fits 1995-2003 Ford Windstar, rear
• Quality-built premium brake pad formulation for dependable stopping performance
• Application-specific friction compound for vehicle-matched braking response
• Copper-free formula for 2025 compliance
• Low brake dust and noise-focused pad design
• Integrally molded friction material
• Adhesive-backed pad shims and pad shims included
• Abutment clips included
• New condition

Detailed Description

This MPA Electrical disc brake pad set is built for rear brake service on the Ford Windstar and is identified by part number 1001-0664M. The pad formula is engineered for the application rather than a one-size-fits-all approach, helping restore original-style stopping response across a wide temperature range. The copper-free friction material supports current compliance requirements while also targeting low dust and quiet operation.

For shoppers searching for rear brake pads for 1995-2003 Ford Windstar, rear disc brake pad set 1001-0664M, or Ford Windstar rear brake replacement pads, this part provides a direct fitment match for the listed vehicles. The included abutment clips and pad shims help complete the pad-to-bracket interface, while the adhesive-backed shim design supports stable pad contact during braking.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It Can Address

• Squealing or noisy rear brakes
• Excessive brake dust buildup on rear wheels
• Reduced stopping response from worn rear pads
• Uneven pad wear caused by aged friction material
• Brake vibration related to deteriorated pad shims

Installation Notes and Tips

Inspect the rear rotors, caliper hardware, and slide surfaces before installation. Clean the bracket contact points thoroughly, apply brake lubricant where appropriate, and verify caliper movement before returning the vehicle to service. Because mounting hardware and brake lubricant are not included, reuse or replace those items as needed during the brake job. Confirm rear fitment for your specific 1995-2003 Ford Windstar before ordering.

Quality Assurance

MPA Electrical positions this brake pad set as a premium replacement with application-specific friction engineering and copper-free construction for dependable performance across a broad thermal range. Part number 1001-0664M is supplied new and built for rear brake service on the listed Ford Windstar applications.