MPA Electrical 1002-0817M Disc Brake Pad Set - Front

Front Brake Pads for Scion tC and Toyota Celica

MPA Electrical 1002-0817M is a front disc brake pad set built for demanding driving conditions. The semi-metallic friction material is formulated for repeated stops, higher heat, towing, and off-road use, while the included shims and abutment clips support quieter, more consistent brake operation.

Key Features

• Semi-metallic friction material for heavy-duty braking performance
• Front disc brake pad set for direct replacement service
• Pad shims included, with adhesive-backed shim construction
• Abutment clips included for proper pad support
• Integrally molded friction material attachment
• New condition replacement part
• Part number 1002-0817M for ordering and fitment verification

Detailed Product Overview

Built for vehicles that see frequent stop-and-go use, MPA Electrical 1002-0817M brake pads are suited to front brake service where heat and durability matter. The semi-metallic compound is a practical choice for drivers who need stable braking under load, including fleet duty, towing, and repeated braking in daily use. This front brake pad set fits 2005-2010 Scion tC, front and 2000-2005 Toyota Celica, front. The part number 1002-0817M also helps confirm the correct application when comparing brake pad options for Scion tC and Toyota Celica front brake repair.

Common Problems This Part Can Address

• Worn front brake pads causing reduced stopping performance
• Brake noise from missing or worn pad shims
• Uneven pad contact related to aged abutment hardware
• Brake fade during repeated stops or higher-heat driving
• Brake service needs on fleet, towing, or daily-driver applications

Installation Notes and Tips

Inspect rotors, calipers, and slide hardware before installation. Clean the caliper bracket contact points, confirm the abutment clips are seated correctly, and apply brake lubricant only where specified by the vehicle service procedure, since lubricant is not included. Because mounting hardware is not included, reuse or replace any required service hardware as needed. Verify front-position fitment against the vehicle application before installation.

Quality Assurance

MPA Electrical brake pads are built as a new replacement part with semi-metallic friction material, included shims, adhesive-backed pad shims, and abutment clips for a service-ready front brake repair. Part number 1002-0817M is listed for the confirmed applications shown above.