MPA Electrical 1002-1119M Disc Brake Pad Set - Front

Front Brake Pads for Hummer H3 and H3T

MPA Electrical 1002-1119M is a front disc brake pad set built for heavy-duty braking demands. It uses a semi-metallic friction material with integrally molded attachment, pad shims, adhesive-backed pad shim, and abutment clips to support consistent braking performance in demanding service.

Key Features

• Semi-metallic friction material for high-heat, repeat-stop use
• Front disc brake pad set for confirmed Hummer fitment
• Pad shims included for noise control and stable contact
• Adhesive-backed pad shim included
• Abutment clips included
• Integrally molded friction material attachment
• Regular grade replacement part
• New condition

Detailed Product Overview

MPA Electrical 1002-1119M is engineered for front brake service on 2006-2010 Hummer H3 and 2009-2010 Hummer H3T models. The semi-metallic compound is suited to higher heat loads and demanding driving conditions such as towing, off-road use, and frequent stop-and-go operation. This part number, 1002-1119M, is a direct fit for the listed front applications and is a practical choice for fleet and work-oriented braking needs.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Helps Address

• Reduced stopping performance from worn front brake pads
• Brake fade during repeated stops or heavy-duty use
• Noise caused by worn pad shims or contact surfaces
• Uneven braking feel from degraded friction material
• Front brake service needs on Hummer H3 and H3T models

Installation Notes and Tips

Verify front axle fitment before installation. Inspect rotors, caliper hardware, and pad contact points for wear or damage before replacing the pads. Clean the caliper bracket surfaces thoroughly and apply brake lubricant only where specified by the vehicle service procedure, since lubricant is not included. Because mounting hardware is not included, reuse only serviceable hardware or replace it separately if needed.

Quality Assurance

MPA Electrical 1002-1119M is a new brake pad set built with semi-metallic friction material, included shims, adhesive-backed shim material, and abutment clips to support consistent fit and serviceability in the listed applications.