MPA Electrical 11486 Alternator

Remanufactured Alternator for Camaro

MPA Electrical Part Number 11486 is a remanufactured 12-volt alternator built for charging-system replacement on select Chevrolet Camaro applications. It delivers 150 amps and uses an internal regulator, internal fan, and a 6-groove serpentine pulley for the specified fitment.

This remanufactured alternator is built by MPA Electrical and uses Valeo as the manufacturer reference. It is a direct-fit charging component for 2010-2015 Chevrolet Camaro models with the 6S standard pulley note, making it a focused replacement for Camaro charging system service.

Key Features

• MPA Electrical remanufactured alternator, Part Number 11486
• 150 amp output for 12-volt charging systems
• Internal voltage regulator
• Internal cooling fan
• 6-groove serpentine pulley
• Clockwise rotation with 1:00 clock position
• Manufacturer reference: Valeo

Detailed Description

MPA Electrical 11486 is a remanufactured alternator engineered for Chevrolet Camaro charging-system replacement where the vehicle uses the 6S standard pulley configuration. With 150 amps of output, this unit supports the electrical demands of the vehicle’s charging circuit while maintaining the correct pulley, rotation, and regulator setup for the listed application. If you are searching for a remanufactured alternator for a 2010-2015 Chevrolet Camaro, Part Number 11486 is the relevant match for the specified fitment.

This part cross-references Quality-Built 11486 for the same application.

What It Helps Address

• Battery warning light caused by alternator output loss
• Low charging voltage during driving
• Dim lights or unstable electrical performance
• Battery drain related to charging-system failure
• Noise or belt-drive issues tied to a worn alternator pulley or bearing assembly

Installation Notes and Tips

Verify the vehicle’s pulley configuration, rotation, clock position, and connector layout before installation. This alternator is listed for 2010-2015 Chevrolet Camaro models with the 6S standard pulley note, so matching the original charging-system specifications is important for proper fitment. Confirm belt alignment and charging voltage after installation.

Quality Assurance

MPA Electrical remanufactured components are built to restore charging-system function using application-specific specifications. Part Number 11486 is identified with Valeo as the manufacturer reference and is supported by listed interchange data for catalog matching.