MPA Electrical 15001 Alternator

200A Remanufactured Alternator for Ford and Lincoln

MPA Electrical Part Number 15001 is a remanufactured 12-volt alternator built for charging-system service on select Ford and Lincoln vehicles. It delivers 200 amps with an internal regulator, internal fan, and a 6-groove serpentine pulley for clockwise rotation.

This remanufactured alternator is a direct-fit charging component for 2010-2012 Ford Taurus, 2010-2012 Ford Flex, 2011-2012 Ford Explorer, 2010-2012 Lincoln MKS, and 2010-2012 Lincoln MKT applications that use the 200 amp alternator setup. Part number 15001 is also referenced in interchange listings for related OE and aftermarket applications.

Key Features

• 200 amp output for high-demand charging systems
• 12-volt electrical system
• Internal voltage regulator
• Internal cooling fan
• 6-groove serpentine pulley
• Clock position: 10:30
• Clockwise rotation
• Remanufactured by MPA Electrical

Detailed Description

MPA Electrical 15001 is a remanufactured alternator with Mitsubishi manufacturer design characteristics, built for vehicles that require a 200 amp charging unit. The internal regulator helps control charging output, while the internal fan supports alternator cooling during operation. The 6-groove serpentine pulley and clockwise rotation match the specified belt-drive configuration for the listed Ford Explorer, Ford Flex, Ford Taurus, Lincoln MKS, and Lincoln MKT fitments. Use this part number 15001 when replacing a worn or failing alternator in the confirmed applications.

This part cross-references Quality-Built 12878 for the same application.

Common Problems This Part Can Address

• Battery warning light or charging-system warning on the dash
• Low charging output from a failing alternator
• Dim lights or electrical instability at idle or under load
• Battery not maintaining charge during normal driving
• Noise or wear related to alternator failure in the charging system

Installation Notes and Tips

• Verify the vehicle uses the 200 amp alternator configuration before ordering.
• Confirm pulley groove count, rotation, and clock position against the original unit.
• Inspect the belt, battery, and charging connections during replacement.
• Check the charging system after installation to confirm proper output.
• Match the application to the listed fitment for Ford Explorer, Ford Flex, Ford Taurus, Lincoln MKS, or Lincoln MKT.

Quality Assurance

MPA Electrical remanufactured components are rebuilt for charging-system replacement use and are specified here with the listed electrical and mounting characteristics. Part number 15001 is intended for the confirmed vehicle applications shown above.