MPA Electrical 17796N Starter Motor

Starter for Mitsubishi and Chrysler Applications

MPA Electrical 17796N is a 12-volt starter built with a permanent magnet gear reduction design and a 1.4 kW rating. It uses a Mitsubishi-manufactured configuration with clockwise rotation and an 8-tooth drive for direct replacement service on select Chrysler, Dodge, and Mitsubishi vehicles.

MPA Electrical’s New line focuses on replacement electrical components for starting and charging repairs. This starter is built for the listed applications and is a practical choice when diagnosing slow cranking, no-start conditions, or starter noise on the covered vehicles.

Key Features

• Part number: 17796N
• 12-volt starter for starting system repair
• Permanent magnet gear reduction design
• 1.4 kW output rating
• Mitsubishi manufacturer configuration
• Clockwise rotation
• 8-tooth drive
• Fits select Chrysler Sebring, Dodge Stratus, Mitsubishi Eclipse, Mitsubishi Outlander, and Mitsubishi Galant applications

Application Details

Compatible with 1999-2003 Mitsubishi Galant, 2000-2005 Mitsubishi Eclipse, 2001-2005 Chrysler Sebring, 2001-2005 Dodge Stratus, and 2003-2004 Mitsubishi Outlander. For Outlander models, the listing applies to vehicles built to 6/2003 with a 216mm length starter. This part cross-references BBB Industries 17796 for the same application.

What This Starter Helps Address

• Engine no-crank or intermittent crank conditions
• Slow cranking caused by a worn starter motor
• Starter grinding or drive engagement issues
• Electrical starting faults on covered Mitsubishi, Chrysler, and Dodge models
• Replacement needs after starter wear or internal failure

Installation Notes and Tips

Verify the vehicle year, engine configuration, starter length, and tooth count before installation. Confirm clockwise rotation and 12-volt system requirements match the original unit. On 2003-2004 Mitsubishi Outlander applications, check the build date and 216mm starter length note before ordering.

Quality Assurance

MPA Electrical New starters are built as replacement electrical components for the listed fitments and specifications. Confirm all OE-style dimensions and electrical details against the original starter before installation to ensure proper fit and operation.