MPA Electrical 19095N Starter Motor

Starter for Land Rover LR2

The MPA Electrical 19095N is a 12-volt starter built for the 2008-2012 Land Rover LR2. It uses a permanent magnet gear reduction design with a 1.1 kW rating, clockwise rotation, and a 10-tooth drive for direct replacement service. This Bosch-manufactured unit is a practical choice when diagnosing hard-start or no-crank conditions on the LR2.

Key Features

• Part number: 19095N
• Permanent magnet gear reduction starter design
• 1.1 kW output for 12-volt systems
• Clockwise rotation
• 10-tooth drive
• Bosch manufacturer specification
• Compatible with 2008-2012 Land Rover LR2

Product Details

MPA Electrical 19095N is a starter assembly for Land Rover LR2 models from 2008 through 2012. The permanent magnet gear reduction layout helps deliver compact packaging with efficient cranking performance, while the 1.1 kW rating and 12-volt electrical specification match the vehicle’s starting system requirements. If you are replacing a worn starter on a 2010 Land Rover LR2 or another model year in the same range, this unit provides the correct rotation and tooth count for the application. The part number 19095N is useful when verifying the exact replacement before ordering.

Common Problems This Starter Can Address

• No-crank condition when the ignition is turned
• Slow or weak engine cranking
• Intermittent starter engagement
• Grinding or abnormal starter drive noise
• Starting issues caused by a worn internal starter motor

Installation Notes and Tips

Confirm the vehicle’s year, make, and model before installation. Verify clockwise rotation, 12-volt system voltage, 1.1 kW rating, and 10-tooth drive count against the original unit. For a 2008-2012 Land Rover LR2 starter replacement, compare the mounting and electrical connections to the removed part before final installation. This part cross-references Bosch (e.g., 19095N) for the same application.

Quality Assurance

MPA Electrical supplies this starter under the New brand line, with Bosch listed as the manufacturer source for the unit specification. The part is built to match the stated electrical and mechanical requirements for the LR2 application.