MPA Electrical B1082 Power Brake Booster

Remanufactured Vacuum Brake Booster for Jeep Wrangler

MPA Electrical B1082 is a remanufactured vacuum power brake booster built for 1987-1990 Jeep Wrangler applications. It is engineered to deliver strong braking assist with reduced pedal effort, using a single-diaphragm design and a metal housing for standard replacement service.

The MPA Electrical brake booster line focuses on remanufactured replacement units with new replacement and specially treated components, plus end-of-line testing to verify vacuum seal and pressure transfer performance. This B1082 unit is supplied without a master cylinder.

Key Features

• Fits 1987-1990 Jeep Wrangler, N/A
• Part number: B1082
• Vacuum booster design with single diaphragm
• Remanufactured standard replacement brake service grade
• Metal housing construction
• Master cylinder not included
• 2 mounting studs with 3/8-16 master cylinder stud thread size
• Diaphragm diameter: 8.73 in. (221.74 mm)

Detailed Description

MPA Electrical B1082 is a reman vac power brake booster for Jeep Wrangler models from 1987 through 1990. It is built as a vacuum-type, single-diaphragm booster to restore brake assist performance in vehicles that rely on engine vacuum for pedal boost. The remanufactured construction uses treated and replacement components to help maintain vacuum integrity and consistent pressure transfer. If you are searching for a Jeep Wrangler brake booster replacement, Jeep Wrangler vacuum brake booster, or B1082 brake booster for 1987-1990 Jeep Wrangler, this unit matches the listed application.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Hard brake pedal feel
• Reduced brake assist from a failing vacuum booster
• Brake response issues caused by internal diaphragm wear
• Vacuum seal loss in the booster housing
• Pressure transfer problems in the brake assist system

Installation Notes and Tips

Verify the master cylinder is reused or replaced separately, since it is not included with this booster. Confirm the 2-stud mounting pattern, master cylinder stud thread size, and vehicle brake system layout before installation. Inspect vacuum supply, check the brake pedal rod setup, and replace worn seals or related brake components as needed during service.

Quality Assurance

MPA Electrical subjects each booster to 100% end-of-line testing with proprietary equipment to check performance before release. The remanufactured process is focused on vacuum seal integrity, reliable pressure transfer, and consistent braking assist for the listed Jeep Wrangler applications.