MPA Electrical BC182792 Disc Brake Caliper - Rear Left

Remanufactured Rear Left Brake Caliper

MPA Electrical BC182792 is a remanufactured rear left disc brake caliper built for select Nissan and INFINITI applications. It is a floating caliper with a cast iron body, steel piston, silver coated finish, and included caliper slides and mounting bracket for the listed fitments.

Compatible with 2003-2009 Nissan Quest, 2003-2007 Nissan Murano, 2003-2005 INFINITI G35, and 2003-2005 Nissan 350Z rear left brake applications, BC182792 is built for direct replacement service. This part cross-references 44011AL500 for the same application.

Key Features

• Remanufactured disc brake caliper for rear left position
• Cast iron caliper housing with coated silver finish
• Floating caliper design with one steel piston
• Caliper slides and mounting bracket included
• 10.0 mm inlet thread diameter
• 12.0 mm mounting hole diameter
• No pads included
• Mounting bolts not included

Built for OE-Style Brake Service

BC182792 is remanufactured at an IATF 16949 facility using a controlled inspection process for core selection, cleaning, machining, and final assembly. Heavily pitted or severely corroded cores are removed from service early in the process, while reusable steel components are cleaned and inspected before assembly. Threads are chased for proper fit, rubber components are material tested, and the finished caliper receives a corrosion-resistant coating for OE-style appearance and rust protection.

For Nissan Quest, Nissan Murano, INFINITI G35, and Nissan 350Z rear brake repairs, this caliper supports a direct replacement approach where the original caliper has seized, leaked, or worn unevenly. BC182792 is also a practical choice when the original rear left caliper shows corrosion, sticking slide movement, or piston wear.

Common Problems This Part Addresses

• Rear brake drag caused by a sticking caliper piston
• Uneven braking from worn or seized caliper slides
• Brake fluid leakage at the caliper body or inlet area
• Corrosion on the original rear left caliper housing
• Poor brake response from a damaged or worn caliper assembly

Installation Notes

Verify rear left fitment by year, make, model, and brake configuration before installation. Transfer or replace brake pads separately, since pads are not included. Inspect brake hoses, banjo hardware, and mounting surfaces during service, and bleed the hydraulic system after installation to remove air from the circuit.

BC182792 is listed for 2003-2009 Nissan Quest rear left, 2003-2007 Nissan Murano rear left, 2003-2005 INFINITI G35 rear left, and 2003-2005 Nissan 350Z rear left applications. Confirm the vehicle uses the specified rear brake setup before ordering.

Quality Assurance

MPA Electrical remanufactures this caliper through multiple quality checkpoints, including core inspection, machining, cleaning, thread verification, and final inspection before release. The process is focused on consistent fit, sealing, and corrosion resistance for the listed applications.