MPA Electrical BC182802 Disc Brake Caliper - Front Left

Remanufactured Front Left Brake Caliper

MPA Electrical BC182802 is a remanufactured disc brake caliper for the front left position on select 1999-2002 INFINITI G20 models. It is built from a cast iron caliper body with a coated silver finish and is processed through multiple quality checkpoints for consistent brake performance.

Fits 1999-2002 INFINITI G20, front left. This part cross-references 410115J000 for the same application.

Key Features

• Remanufactured disc brake caliper for brake hydraulic service
• Cast iron caliper casting with coated silver finish
• Floating caliper design with one steel piston
• Caliper slides and mounting bracket included
• Inlet thread diameter: 10.0 mm
• Mounting hole diameter: 12.0 mm
• Pads not included
• Caliper finish or coating may vary

Detailed Description

BC182802 is remanufactured at an IATF 16949 facility using a controlled process that starts with core inspection and rejection of heavily pitted or severely corroded units. Reusable steel components are cleaned and inspected before assembly, while rubber components are material tested to support consistent sealing and operation. The caliper threads are cleaned and chased, then verified during final inspection with a go/no-go test. For rear actuated calipers, banjo bolts, crush washers, and friction hardware are replaced with new components during remanufacturing; this unit is built to OE-style service expectations for the INFINITI G20 front left brake position.

Common Problems This Part Can Address

• Brake drag caused by a sticking caliper piston or slide
• Uneven braking from worn or corroded caliper components
• Brake fluid leakage at the caliper inlet or sealing surfaces
• Poor brake response from internal caliper wear
• Noise or pull related to caliper hardware condition

Installation Notes and Tips

Confirm the vehicle is a 1999-2002 INFINITI G20 with front left caliper application before ordering. Inspect brake hoses, pads, rotors, and mounting surfaces during installation, and bleed the hydraulic system after replacement. Verify inlet thread size and mounting dimensions match the original caliper. Because pads are not included, reuse only serviceable related brake components or replace them as needed.

Quality Assurance

MPA Electrical remanufactures this caliper through a multi-step inspection process that includes core rejection criteria, component cleaning, thread chasing, and final functional checks. Aluminum calipers are machined at the inlet for sealing accuracy, phenolic pistons are replaced with new parts, and cast iron calipers receive corrosion-resistant zinc dichromate protection where applicable. BC182802 is a remanufactured brake caliper built for verified fitment and OE-style service on the INFINITI G20.