MPA Electrical BC5602 Disc Brake Caliper - Front Left

Remanufactured Front Left Brake Caliper

MPA Electrical BC5602 is a remanufactured disc brake caliper for the front left position on select Chrysler, Dodge, and Plymouth vehicles. It is built with a cast iron caliper body, a floating design, and a phenolic piston for OE-style brake performance and fitment.

Fits 1995-2000 Chrysler Cirrus, front left. Fits 1996-2000 Chrysler Sebring, front left. Fits 1995-2000 Dodge Stratus, front left. Fits 1996-2000 Plymouth Breeze, front left.

Key Features

• Remanufactured disc brake caliper for brake hydraulic service
• Front left application
• Cast iron caliper casting with coated silver finish
• Floating caliper design with 1 phenolic piston
• Caliper slides included
• Mounting hardware included
• No brake pads included
• Inlet thread diameter: 0.4375
• Brake caliper finish may vary by unit

Detailed Description

BC5602 is remanufactured at an IATF 16949 facility using a controlled inspection process for core selection, cleaning, machining, and final assembly. During remanufacturing, heavily pitted or severely corroded cores are removed from service, while reusable steel components are cleaned and inspected before assembly. Phenolic pistons are replaced with new components, and threaded areas are cleaned and chased for OE-type thread engagement. The caliper is finished with corrosion-resistant coating for a clean OE-style appearance and added rust protection.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Use BC5602 when servicing a front left brake caliper on Chrysler Cirrus, Chrysler Sebring, Dodge Stratus, or Plymouth Breeze models listed above.

Common Repair Uses

• Restoring braking force at the front left wheel
• Replacing a sticking or seized caliper
• Correcting uneven pad wear caused by caliper drag
• Addressing brake fluid leakage at the caliper body or inlet area
• Repairing corrosion-related caliper wear on older vehicles

Installation Notes and Tips

Verify the inlet thread diameter, caliper slide condition, and front left position before installation. Transfer or replace brake pads as needed, since pads are not included. Bleed the brake system after installation and inspect all connections for leaks. Confirm rotor condition and pad wear pattern before returning the vehicle to service.

Quality Assurance

MPA Electrical remanufactures brake calipers through multiple quality-control checkpoints, including core inspection, machining, cleaning, thread verification, and final inspection. Rubber components are material-tested, and reusable metal components are checked before assembly to support consistent brake performance.