MPA Electrical NM2708 Brake Master Cylinder

Brake Master Cylinder for Jeep TJ and Cherokee

Restore consistent brake pedal response with this new brake master cylinder from MPA Electrical. Built as a standard replacement for front disc brake applications, NM2708 is engineered for Jeep TJ, Jeep Cherokee, Jeep Grand Cherokee, and Chrysler/Plymouth Prowler models listed below.

MPA Electrical’s New with front disc brakes product line focuses on direct-fit brake hydraulics for vehicles that need dependable OE-style replacement parts. This master cylinder is tested against OE specifications using controlled validation processes to help deliver consistent braking performance after installation.

Key Features

• Brake master cylinder for brake hydraulic repair and replacement
• Standard replacement grade for factory-style fit and function
• 1-inch master cylinder bore diameter
• Aluminum master cylinder construction
• Reservoir included
• Master cylinder cap included
• Gasket or seal included
• Uses DOT 3 brake fluid
• Two mounting holes with 0.36-inch mounting hole diameter
• New condition

Detailed Description

MPA Electrical NM2708 is a brake master cylinder built for vehicles equipped with front disc brakes. It is a direct replacement hydraulic component for 1997-2006 Jeep TJ, 1995-2001 Jeep Cherokee, 1995-1998 Jeep Grand Cherokee, 2001-2002 Chrysler Prowler, and 1997, 1999-2001 Plymouth Prowler applications. This part cross-references OE numbers 4761941 and 4882872 for the same application. The aluminum body, 1-inch bore, included reservoir, and included cap support a complete master cylinder replacement for common brake system service needs.

What It Helps Address

• Low or inconsistent brake pedal feel
• Internal master cylinder seal wear
• Brake fluid leakage at the master cylinder
• Loss of hydraulic pressure in the brake system
• Brake performance issues related to an aging hydraulic unit

Installation Notes and Tips

Verify front disc brake configuration before ordering. This master cylinder uses DOT 3 brake fluid and mounts with two holes; mounting hardware, brake booster, push rod, sensor, and brake pressure switch are not included. Always bench bleed the master cylinder before installation, then bleed the full brake system after mounting to remove trapped air and restore proper pedal feel.

Quality Assurance

MPA Electrical tests each unit against OE specifications using proprietary processes and strict protocols to help ensure consistent braking performance out of the box. NM2708 is a new standard replacement brake master cylinder built for the listed Jeep and Prowler applications.