/live/media/MV/MV_NM4107_FRO.JPG)
OE Quality
60-Day Returns
MPA Electrical NM4107 Brake Master Cylinder
Brake Master Cylinder for Ford Freestar and Windstar
Restore consistent brake pedal response with this MPA Electrical brake master cylinder, part number NM4107. It is a standard replacement unit built for 2002-2003 Ford Windstar and 2004-2005 Ford Freestar models with front disc brakes.
MPA Electrical’s New with front disc brakes product line focuses on direct-fit hydraulic brake components for specific vehicle applications. NM4107 is engineered to match OE specifications and is tested against those standards to help deliver reliable braking performance after installation.
Key Features
- Standard replacement brake master cylinder
- Aluminum master cylinder body
- 1.0625 in. bore diameter
- Gasket or seal included
- Uses DOT 3 or DOT 4 brake fluid
- Two mounting holes with 0.355 in. mounting hole diameter
- New part condition
- Fits vehicles with front disc brakes
Detailed Product Overview
NM4107 is a brake master cylinder for Ford Freestar and Ford Windstar applications that require a front disc brake setup. The aluminum construction supports hydraulic brake system operation, while the 1.0625-inch bore diameter and OE-based design help maintain proper pedal feel and braking response. This part cross-references Ford 2F2Z2140AA for the same application.
Common Brake System Issues It May Address
- Low or inconsistent brake pedal feel
- Internal master cylinder leakage
- Brake fluid loss at the hydraulic unit
- Reduced braking response after master cylinder wear
- Brake performance concerns tied to an aging hydraulic assembly
Installation Notes and Tips
Verify vehicle fitment by year, make, model, and brake configuration before installation. This master cylinder does not include the reservoir, cap, push rod, brake booster, sensor, pressure switch, mounting hardware, or mounting bracket. Use the correct DOT 3 or DOT 4 brake fluid, and bleed the brake system thoroughly after installation to remove air from the hydraulic lines.
Quality Assurance
MPA Electrical tests each unit using OE sample references and controlled inspection processes to help ensure consistent performance and dimensional accuracy. NM4107 is a new, standard replacement brake master cylinder built for dependable hydraulic brake restoration on the listed Ford applications.
| Brand | MPA Electrical |
|---|---|
| Part Number | NM4107 |
| Position | New with front disc brakes |
| Mounting Hardware Included | No |
| Grade Type | Standard replacement |
| Gasket Or Seal Included | Yes |
| Mounting Hole Quantity | 2 |
| Master Cylinder Bore Diameter | 1.0625 |
| Brake Booster Included | No |
| Master Cylinder Cap Included | No |
| Master Cylinder Material | Aluminum |
| Push Rod Included | No |
| Reservoir Included | No |
| Sensor Included | No |
| Mounting Hole Diameter | 0.355 |
| Mounting Bracket Included | No |
| Brake Pressure Switch(s) Included | No |
| Fluid Type | Dot 3 or dot 4 |
| Product Condition | New |
This part fits 4 vehicles. Search below:
| Year | Make | Model | Position | Notes |
|---|---|---|---|---|
| 2005 | Ford | Freestar | N/A | New with front disc brakes |
| 2004 | Ford | Freestar | N/A | New with front disc brakes |
| 2003 | Ford | Windstar | N/A | New with front disc brakes |
| 2002 | Ford | Windstar | N/A | New with front disc brakes |
* Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
This part directly replaces or is cross-referenced with the following part numbers:
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.