MPA Electrical NM55362 Brake Master Cylinder

Brake Master Cylinder for Honda Element

Restore consistent brake pedal response with this MPA Electrical brake master cylinder for the 2003-2006 Honda Element with front disc brakes. Built as a standard replacement, NM55362 is engineered to match OE specifications for dependable hydraulic performance right out of the box.

MPA Electrical’s New with front disc brakes product line focuses on direct-fit brake hydraulic replacements that are tested against OE samples and strict production protocols. For a Honda Element brake master cylinder replacement, this line is aimed at restoring factory-style braking feel and fluid control.

Key Features

• Fits 2003-2006 Honda Element, N/A, with front disc brakes
• Standard replacement brake master cylinder
• Aluminum master cylinder body with plastic reservoir
• 0.938 in. bore diameter for OE-style hydraulic output
• Reservoir and cap included
• Gasket or seal included
• Uses DOT 3 or DOT 4 brake fluid
• New condition replacement part
• Part number NM55362 for ordering and reference

Detailed Description

NM55362 is a brake master cylinder for the Honda Element that helps restore hydraulic pressure in the braking system. It is built with an aluminum master cylinder housing, plastic reservoir, and a 0.938-inch bore diameter, with two mounting holes and a 0.334-inch mounting hole diameter. The unit includes the reservoir, cap, and gasket or seal, while the brake booster, push rod, dust boot, mounting hardware, sensor, mounting bracket, and brake pressure switch are not included. This part cross-references Honda 46100SCVA51 for the same application. If you are searching for a Honda Element brake master cylinder, NM55362 provides a direct replacement option for vehicles equipped with front disc brakes.

Common Problems This Part Can Address

• Low or inconsistent brake pedal feel
• Internal master cylinder leakage
• Brake fluid loss at the hydraulic unit
• Reduced braking response from worn seals
• Need for a direct replacement on a Honda Element brake system

Installation Notes and Tips

Before installation, verify the vehicle is a 2003-2006 Honda Element with front disc brakes and confirm the bore size and mounting layout match the original unit. Bench bleeding the master cylinder before installation helps remove trapped air and supports proper pedal feel after the system is filled with DOT 3 or DOT 4 fluid. Inspect the brake lines, booster interface, and surrounding hydraulic components for wear or contamination during replacement.

Quality Assurance

MPA Electrical tests each brake master cylinder against OE specifications using proprietary processes and strict protocols based on an extensive OE sample library. That validation process is used to help ensure consistent braking performance from the NM55362 unit.