MPA Electrical WH800057 Wheel Bearing - Front

Front Wheel Bearing for Honda and Acura

MPA Electrical WH800057 is a new front wheel bearing built with a steel construction and an encoder-style ABS interface. It is a Quality-Built Hubs & Bearings component for drivers replacing a worn front hub bearing on select Honda CR-V, Honda Accord, Honda Clarity, Acura RDX, and Acura RLX applications.

• New front wheel bearing assembly
• Steel construction for durable service
• Encoder ABS type for vehicles with wheel speed sensing at the hub
• Hub pilot diameter: 3.583 inch
• No gasket or seal included
• Not greaseable
• Direct replacement for select front driveline and axle applications

Fitment Details

• Fits 2017-2024 Acura RDX, front
• Fits 2017-2022 Honda CR-V, front
• Fits 2017-2021 Honda Clarity, front
• Fits 2019-2020 Acura RLX, front
• Fits 2018-2020 Honda Accord, front
• Fits 2017-2018 Acura RLX, front; wheel bearing; axle nut torque spec: refer to OE service manual
• Fits 2013-2016 Acura RDX, front; wheel bearing; axle nut torque spec: refer to OE service manual
• Fits 2014-2016 Acura RLX, front; wheel bearing; axle nut torque spec: refer to OE service manual
• Fits 2012-2016 Honda CR-V, front; wheel bearing; axle nut torque spec: refer to OE service manual

Detailed Description

WH800057 is a front wheel bearing engineered for OE-style service on Honda and Acura platforms that use an encoder ABS setup. The steel bearing body supports consistent hub operation, while the integrated encoder design works with the vehicle’s wheel speed sensing system. This part number, WH800057, is a practical replacement choice when servicing front-end noise, looseness, or bearing wear on the Honda CR-V, Honda Accord, Honda Clarity, Acura RDX, and Acura RLX.

This part cross-references Honda 4300-T0G-951 for the same application.

Common Replacement Reasons

• Front wheel bearing noise or growling
• Excessive play or looseness at the hub
• ABS warning caused by a failed encoder bearing
• Uneven wheel rotation from bearing wear
• Service replacement after hub contamination or damage

Installation Notes

Confirm year, make, model, and front position before installation. Vehicles listed with axle nut torque notes should be tightened to the OE service manual specification. Inspect the hub, knuckle, and axle components for wear or damage during service, and verify ABS sensor operation after installation.

Quality Assurance

MPA Electrical supplies this Quality-Built Hubs & Bearings wheel bearing as a new replacement component for select Honda and Acura front applications. WH800057 is built to match the listed encoder ABS configuration and hub dimensions for accurate fitment.