MTC Ronak VR181 Drive Shaft Center Support

Drive Shaft Center Support for Driveline Service

MTC Ronak VR181 is a drive shaft center support for driveline and axle service. It is a direct-fit replacement option for applications that use a center support bearing assembly without an included bearing, and it cross-references Monroe Shocks & Struts 675367 for the same application.

Key Features

• Drive shaft center support for driveline repair
• Bearing(s) included: No
• Part number VR181 for ordering and identification
• Cross-reference: Monroe Shocks & Struts 675367

Product Details

This MTC Ronak drive shaft center support is built for vehicles that require a center support mount in the driveline assembly. The no-bearing configuration lets you match the support to the service parts already specified for the vehicle, which is important when replacing a worn carrier support on a Honda Civic or similar driveline application. Use VR181 when the original setup calls for a center support without an integrated bearing, and verify the driveline layout before installation.

Common Problems It Can Address

• Driveline vibration from a worn center support
• Noise caused by a deteriorated support mount
• Excessive shaft movement under load
• Wear at the center support location in the drive shaft assembly

Installation Notes

Confirm the vehicle’s driveline configuration and compare the original support before installation. Because bearing(s) are not included, reuse or source the correct bearing separately if the application requires one. Check shaft alignment, mounting points, and driveline condition during service to help ensure proper operation.

Quality Assurance

MTC Ronak VR181 is identified by part number VR181 and is cataloged for driveline service applications where a center support is specified. Review the original equipment layout and interchange reference before ordering to confirm the correct match.