National 03062 Wheel Bearing - Front Outer

National 03062 Taper Bearing Cone for Front Outer Service

National 03062 is a taper bearing cone built for driveline and axle service where precise bearing support matters. It is listed for the 1961 Ford Escort front outer position and is a direct fit reference for that application. The National 03062 taper bearing cone is a practical choice when replacing a worn wheel bearing component on a 1961 Ford Escort.

Key Features

• Taper bearing cone for wheel bearing service
• Cone bore: 0.6250 in. / 15.8750 mm
• Cone length: 0.5780 in. / 14.6810 mm
• Cone radius: 0.0460 in. / 1.1680 mm
• Front outer position fitment for 1961 Ford Escort
• National part number 03062 for catalog and cross-reference use

Product Details

National Oil Seals & Bearings supplies this taper bearing cone as part of its premium bearing and seal lineup. The cone dimensions are important for proper bearing setup, and the listed bore, length, and radius help identify the correct replacement for the hub or spindle assembly. This part cross-references SKF BR03062 for the same application. For buyers searching wheel bearing cone replacement for 1961 Ford Escort front outer service, National 03062 provides a clear OE-style reference point.

Common Issues This Part Can Address

• Excessive wheel bearing play at the front outer position
• Noise from a worn or damaged taper bearing cone
• Rough wheel rotation caused by bearing wear
• Incorrect bearing dimensions during hub service
• Need for a direct replacement bearing cone on a 1961 Ford Escort

Installation Notes and Tips

Verify the bearing dimensions against the existing component before installation. Clean the hub and spindle surfaces thoroughly, inspect the matching bearing cup, and pack or lubricate the bearing according to the vehicle service procedure. Confirm the front outer application on the 1961 Ford Escort before assembly, and check bearing preload or end play after installation.

Quality Assurance

National is known for oil seals and bearings across a broad automotive service range, and this part follows that product focus with published dimensional data for identification and fitment verification. Use the part number 03062 and the listed measurements to confirm the correct taper bearing cone before service.