National 205044 Wheel Seal - Front Inner

National 205044 Wheel Seal Overview

National 205044 is a wheel seal built for driveline and axle sealing applications that require a 2.000 inch shaft diameter and a 2.968 inch outside diameter. This felt oil seal measures 0.500 inch wide and is part of National’s 205000 series, a line backed by decades of sealing expertise for modern vehicle service.

Use this seal when servicing axle and hub sealing points on vehicles such as Honda Civic and Toyota Corolla applications where the specified dimensions match the original setup. The National 205044 part number is also commonly searched as 205044 for direct replacement lookup.

Key Features

• Wheel seal / oil seal for driveline and axle sealing systems
• Inside diameter: 2.000 in. / 50.800 mm
• Outside diameter: 2.968 in. / 75.390 mm
• Housing bore: 2.964 in. / 75.290 mm
• Width: 0.500 in. / 12.700 mm
• Felt sealing material
• National 205000 series, Type 205

Detailed Description

National 205044 is an oil seal specified for axle and wheel-end sealing where the shaft, housing bore, and width dimensions must align precisely. The felt construction and measured dimensions make it a practical choice for service work that calls for a 2.000 inch shaft seal with a 2.968 inch outside diameter. If you are searching by part number 205044 or comparing National 205044 against other references, this seal is built around the same dimensional profile used in related driveline sealing applications. This part cross-references SKF 46288 for the same application.

Common Problems This Seal Can Address

• Gear oil seepage at the wheel-end or axle seal area
• Contamination entering the hub or sealing cavity
• Wear-related leakage from an aged felt seal
• Loss of sealing performance after axle or hub service
• Dimensional mismatch when replacing a worn oil seal

Installation Notes and Tips

Verify the shaft diameter, housing bore, and seal width before installation to confirm the National 205044 matches the original specification. Clean the sealing surface and housing thoroughly, and inspect the shaft for grooves or corrosion that could affect sealing performance. For vehicle-specific service, confirm the application against the exact make and model, including Honda Civic and Toyota Corolla fitment references where the dimensions align. The part number 205044 should be matched to the service manual or OE dimensions before pressing the seal into place.

Quality Assurance

National has supplied sealing solutions for more than 75 years and continues to develop sealing components for current vehicle service needs. The 205044 wheel seal reflects that experience with a dimensionally specific design for axle and wheel-end sealing applications.