National 513007 Wheel Bearing and Race Set - Rear Inner

National 513007 Wheel Bearing and Race Set

National 513007 is a taper wheel bearing and race set built with premium-grade steel for durable service in driveline and axle applications. It is a rear inner wheel bearing for 1985-1988 Nissan Maxima, with crowned raceways and rollers to promote even load distribution.

Key Features

• Wheel bearing and race set for rear inner position
• Premium-grade steel construction
• Crowned raceways and rollers for even load distribution
• GEN1 design in the 510000 series
• Dimensions: 1.2500 in bore, 2.1260 in outside diameter, 0.5906 in width
• National 513007 cross-references SKF GRW148 and Standard Ignition S3007 for the same application

Detailed Product Overview

This National wheel bearing set is engineered to match the dimensional requirements of the rear inner hub on 1985-1988 Nissan Maxima models. The cone and cup are specified with a 1.2500 inch bore, 2.1260 inch outside diameter, and 0.5906 inch width, helping ensure proper bearing fitment when replacing worn wheel bearing components. National 513007 is also referenced by part number 513007 in aftermarket catalogs for the same application.

As a taper bearing set, it uses crowned raceways and rollers to help distribute load evenly across the bearing surfaces. That design supports consistent wheel rotation and helps maintain proper hub operation in vehicles that rely on tapered roller bearing construction. If you are sourcing a rear inner wheel bearing for a Nissan Maxima, National 513007 provides a direct replacement path based on the listed fitment.

Common Problems This Part Can Address

• Wheel bearing noise from the rear hub area
• Excessive play or looseness at the wheel end
• Rough rotation caused by worn bearing surfaces
• Replacement of a damaged rear inner wheel bearing on 1985-1988 Nissan Maxima
• Restoration of proper hub support after bearing wear

Installation Notes and Tips

Verify the bearing dimensions, bore, and race measurements against the removed part before installation. Clean the hub and spindle surfaces thoroughly, inspect the mating components for scoring or wear, and pack or lubricate the bearing according to the vehicle service procedure. For best results, replace any damaged races and confirm correct preload or adjustment after assembly. Fits 1985-1988 Nissan Maxima, rear inner.

Quality Assurance

National manufactures this taper bearing set with premium-grade steel and crowned raceways and rollers to support even load distribution. The part number 513007 is listed with direct interchange references, including SKF GRW148 and Standard Ignition S3007, for the same application.