National 710797 Manual Transmission Output Shaft Seal

Manual Transmission Output Shaft Seal Overview

This National manual transmission output shaft seal is built for sealing the output shaft area and helping maintain proper fluid retention in the transmission. It uses a polyacrylate sealing material and a bi-directional lip design for a precise sealing interface.

Compatible with select Chrysler, Dodge, and Dodge Neon applications equipped with the New Process T850 transmission, this part number 710797 is a direct-fit sealing solution for the listed vehicles. Part number 710797 is also referenced by cross numbers 5069052AA and 05069052AA for the same application.

Key Features

• Polyacrylate construction for sealing performance in transmission service.
• Bi-directional lip design for consistent sealing contact.
• Metric dimensions for accurate fitment and service replacement.
• National sealing solution backed by more than 75 years of industry experience.

Detailed Description

National part number 710797 is a manual transmission output shaft seal engineered for the specified Chrysler Sebring, Dodge Stratus, and Dodge Neon applications with the New Process T850 transmission. The seal measures 40.000 mm inside diameter, 58.200 mm outside diameter, and 11.200 mm width, with a flanged outside diameter of 63.000 mm and a housing bore of 58.000 mm. Its polyacrylate material and bi-directional lip design support a secure sealing surface in transmission service.

National focuses on premium sealing solutions and uses current design development to address modern vehicle requirements. This seal is intended for buyers replacing a worn transmission output shaft seal on the listed applications and looking for a dimensionally matched service part. Part number 710797 should be verified against the transmission configuration before installation.

What It Is Used For

• Replacing a leaking manual transmission output shaft seal.
• Addressing fluid seepage around the transmission output shaft.
• Restoring sealing performance after seal wear or hardening.
• Supporting service work on the transmission case and shaft interface.

Installation Notes and Tips

Confirm the transmission is the New Process T850 unit before ordering or installing. Match the seal dimensions to the original part and inspect the shaft surface, housing bore, and sealing area for wear or damage before assembly. Clean the sealing surfaces thoroughly and install the seal squarely to avoid distortion.

Quality Assurance

National has supplied sealing products for more than 75 years and continues to develop solutions for current vehicle applications. Part number 710797 is built as a service replacement seal for the listed fitments.