Nissens 85330 A/C Condenser Fan Assembly - Front or Right

Nissens 85330 A/C Condenser Fan Assembly

The Nissens 85330 A/C condenser fan assembly is a direct-fit thermal management component for select Toyota applications. It uses a 12-volt motor, a 13.31-inch fan diameter, a 5-blade design, and an included shroud to support condenser airflow where factory-style cooling performance is required.

Key Features

• 12-volt A/C condenser fan assembly for HVAC cooling service
• Includes shroud for OE-style mounting and airflow control
• Single fan design with 5 blades
• 13.31-inch fan diameter
• Male connector with 2-pin terminal configuration
• Maximum output power: 96
• No control unit included
• No regulator included

Application Details

Compatible with Toyota Highlander, Toyota Paseo, Toyota Tercel, Toyota Corolla, Toyota MR2, and Toyota Celica applications listed below. This part number, 85330, also cross-references 8360001 for the same application. Nissens 85330 is built for vehicles that need a condenser fan assembly to move air across the A/C condenser and support stable refrigerant-side heat exchange.

• Fits 2001-2003 Toyota Highlander, right, Type-A
• Fits 1997-1998 Toyota Paseo, Diameter_338_mm
• Fits 1992-1995 Toyota Paseo, Diameter_338_mm
• Fits 1998 Toyota Tercel, Diameter_338_mm
• Fits 1996 Toyota Tercel, Diameter_338_mm
• Fits 1992-1993 Toyota Tercel, Diameter_338_mm
• Fits 1994-1997 Toyota Corolla
• Fits 1997 Toyota Tercel, Manual Trans
• Fits 1994-1995 Toyota Tercel, Manual Trans
• Fits 1996 Toyota Paseo, Manual Trans
• Fits 1995 Toyota MR2, Manual Trans
• Fits 1994 Toyota MR2, front
• Fits 1991 Toyota MR2, front
• Fits 1990-1993 Toyota Celica, Diameter_338_mm
• Fits 1993 Toyota Corolla, Japan Built Vehicle
• Fits 1993 Toyota Corolla, Exc.Japan Built Vehicle
• Fits 1993 Toyota MR2
• Fits 1992 Toyota MR2, Diameter_338_mm
• Fits 1989 Toyota MR2, Diameter_338_mm
• Fits 1991 Toyota Tercel

What It Helps Address

• Weak condenser airflow that can reduce A/C heat rejection
• Overheating at the condenser during idle or low-speed operation
• Fan motor failure causing poor cabin cooling performance
• Damaged shroud or fan blade assembly on Toyota HVAC systems
• Electrical connector or terminal mismatch on replacement service

Installation Notes

Verify the connector style, terminal count, voltage, and mounting position before installation. This assembly uses one fan, one connector, and a male terminal layout, so matching the original configuration is important for proper operation. Confirm vehicle-specific notes such as right-side, front, manual transmission, Japan-built, or diameter requirements before ordering.

Quality Assurance

Nissens develops thermal and engine efficiency components to high manufacturing standards and continuously updates its aftermarket range as vehicle technology changes. The 85330 reflects that focus with OE-style fitment details and application-specific construction for Toyota A/C service.