Nissens 89080 A/C Compressor

Nissens 89080 A/C Compressor for BMW

The Nissens 89080 A/C compressor is a FIRST FIT replacement built for BMW 3 Series and X3 applications that use R134A refrigerant. It comes pre-filled with PAG 46 oil and is specified as compressor type 7SBU16C, helping streamline service on BMW 325Ci, 330i, and M3 models.

Key Features

• Part number: 89080
• Refrigerant type: R134A
• Compatible refrigerant oil: PAG 46
• Pre-filled PAG oil for faster installation prep
• FIRST FIT design for time-saving replacement
• Compressor type: 7SBU16C
• 4-groove pulley configuration
• Maximum pulley diameter: 4.3307

Product Details

Nissens develops thermal management components with a focus on consistent manufacturing quality and aftermarket coverage. This A/C compressor is built for direct-fit service on BMW 325Ci, 330Ci, 325i, 330i, 325xi, 330xi, M3, and X3 applications listed below. The Nissens 89080 is a practical choice when replacing a worn compressor in BMW climate control systems that require R134A refrigerant and PAG 46 oil.

This part cross-references Delphi CS20082 and UAC CO29163C for the same application.

Vehicle Fitment

• Fits 2004-2006 BMW 325Ci, N/A
• Fits 2004-2006 BMW 330Ci, N/A
• Fits 2004-2006 BMW M3, N/A
• Fits 2004-2006 BMW X3, N/A
• Fits 2004-2005 BMW 325i, N/A
• Fits 2004-2005 BMW 325xi, N/A
• Fits 2004-2005 BMW 330i, N/A
• Fits 2004-2005 BMW 330xi, N/A
• Fits 2003 BMW 325Ci, N/A, from 09/2002
• Fits 2003 BMW 325i, N/A, from 09/2002
• Fits 2003 BMW 325xi, N/A, from 09/2002
• Fits 2003 BMW 330Ci, N/A, from 09/2002
• Fits 2003 BMW 330i, N/A, from 09/2002
• Fits 2003 BMW 330xi, N/A, from 09/2002
• Fits 2003 BMW M3, N/A, from 09/2002

Common Replacement Reasons

• Loss of cabin cooling performance
• Compressor noise or bearing wear
• Refrigerant pressure issues in the A/C system
• Oil leakage at the compressor assembly
• Failure to maintain consistent air conditioning output

Installation Notes

Verify refrigerant type, oil specification, pulley groove count, and compressor type before installation. This unit is specified for R134A systems using PAG 46 oil, and the FIRST FIT format is intended to reduce prep time during service. Always inspect the system for contamination, replace damaged seals as needed, and confirm correct belt alignment on BMW 325Ci, 330i, and related applications.

Quality Assurance

Nissens positions this compressor within its Genuine Nissens Quality manufacturing standard, with product development focused on aftermarket thermal management coverage and consistent component quality.